Triple Water Spray High Speed Dental Handpiece Stainless Bearng Push Button

Product Parts:
Consists of handpiece head, handle, caudal thread, cartridge.
Working Conditions:
1. Air pressure 0.25~0.30mpa,must be filtrated.
2. Use high speed dental bur with shaft diameter Φ1.59~1.60mm×21-23mm and roghtness less than 0.8um.
3. The capatity of handpieces spray or water spray can be adjusted.

Product Scope:

for drilling and restoration of teeth with high-speed dental burs.

HPA009 Handpiece provide two kind of heads for choice

Features:

1. Clamping force of handpiece is:20-45N
2. Noise not exceed 70dB

Triple Water Spray Handpiece

1. Push Button High Speed Handpiece M4/B2

2. Working Air Pressure:0.20-0.25MPa(0.22MPa prefrred)

3. Rotation Speed:350,000-400,000R.P.M(Standard Head); 280,000-320,000R.P.M(Torque Head);

4. Bur Applicable:Φ1.595-1.600mm"

5. Spray:Triple water spray

Advantage
1. Simple, effective, disassemble it without tools and can be cleaned thoroughly to avoiding cross infection;
2. Stable, quiet, and large torque cartridge;
3. Perfect stable and reliable performance;
4. 135℃ Autoclavable;
5. High-grade material with a stylish design;
6. Application: orthodontics, drill teeth, teeth clean etc.

Maintenance:
1. Considering safety first, please be careful to use it with full attention.
2.It is be used only by dentists who held the dental treatment qualifications.
3. Strictly forbid decomposition and reconstruction by unauthorized.
4. Please test the handpiece outside of patients oral before handle. If feel anomalies, please stop using immediately and contact with our after-sales service center.
5. When appears abnormal during using, please stop it immediately and contact with our after-sales center.
6. It will cause a high noise,when using a center-vibration or bended bur,the bearings of this handpiecehas been wrong, A long time of using in this state will be harm to hearing. Forbid using a vibration or bended bur, if high noise appear, please replace the cartridge early;
7. Do not use a bending , cracking, deformation and unqualified bur. If use it, may cause a snap, or a flying off to injury accident during operation process.
8. Please ensure the bur chuck be clean. If it is with contaminant inside, what may causes bur clamping weaken or cartridge vibration.
9. Please run the bur under the provision rotation-speed by bur manufacturers.
10. Do not crash, especially to avoid falling.
11. Please install a bur standardly before using.
12. Aslo remember to uninstall the bur or the standard stick when not in using.
13. Please unload the bur from the handpiece when the running stopped in completely.