6t No Pollution High Efficiency Fully Automatic Electric Heating Steam Boiler

Electric heating steam boiler in use, must meet the relevant

use requirements, and to ensure normal operation, during

which there are a lot of things to pay attention to and the

conditions of use, so we must carefully read the relevant

instructions before the use, after the operation also need to

do a good job of maintenance, in order to let everyone better

use, we next to a simple understanding of the specific

requirements of the use.

1. Try to use purified soft water, before turning on the water

pipe, the water pipe must be flushed and discharged once, so

as not to sand, iron chips and other debris into the water

tank, into the water pump, damage the water pump.
2. The supply voltage must be in the range of 200V/380V plus

5-10%. If the error is large, the automatic regulator should be

added, otherwise it will cause the electrical burn or steam

displacement reduced.
3. Every day must be discharged once, the level controller,

furnace bile inside, electric heating pipe and water tank must

be maintained once a month, in order to ensure the normal

operation of electric heated steam boiler and extend the

service life. The service life is 8 years.
4. Electric heated steam boiler just started, may be due to the

pipe has air, and water difficulties, encountered in this case,

in the high-pressure vortex pump water joint is equipped with

a gas bolt, counterclockwise 3-4 turns, and so on some water

out of some can be, and then the gas bolt steaming.

5. The pressure controller has been adjusted 0.7Mpa at the

factory, the user may not raise the control pressure on its

own.
In summary, the main factors affecting the steam quality of

electric heated steam boilers are the concentration of pot

water, followed by boiler load, pot water level and boiler

pressure. Therefore, when we use, if its quality is damaged,

then we have to find the reason for our daily operations, so I

hope you can better grasp the relevant use of the need to

know.

WDR6-0.7

Boiler application areas