The Cisco 3925 router, modular Services Performance Engine (SPE) 100, which can be upgraded for even higher performance as next-generation WAN environments evolve.
Table 2 shows the LEDs area description.
LED | Description | |
SYS status LED | Solid green | Solid green indicates normal operation. |
Blinking green | System is booting or is in ROM monitor mode. | |
Amber | System error. | |
Off | Power is off or system board is faulty. | |
ACT status LED | Solid or blinking green | Solid or blinking indicates packet activity between the forwarding and routing engine and any I/O port. |
Off | No packet transfers are occurring. | |
POE | Green | IP phone power is on. |
Amber | IP phone power is not on. | |
PS1 / PS2 | Green | System is running. |
Amber | System is not running. |
Figure 3 shows the back panel of the Cisco router 3925/K9 with LEDs.
Note:
① Compact flash 0 and 1 (0, right) ② ISM ③ PVDM3 0,1,2 and 3 (0, far right) ④ EN (Enable USB console) ⑤ EN (Enable RJ-45 console) ⑥ SFP S ⑦ SFP EN ⑧ S (Speed) ⑨ L (Link)
Table 3 shows the description of these LEDs on the back panel.
LED | Color | Description | Location |
CompactFlash 1 | Green | Flash memory is busy. | Back Panel |
Amber | Initialized with error. | ||
Blinking Green then turns off | CompactFlash is ready for removal. | ||
CompactFlash 0 | Green | Flash memory is busy. | Back Panel |
Amber | Initialized with error. | ||
Blinking Green then turns off | CompactFlash is ready for removal. | ||
S (Speed) | 1 blink + pause | GE port operating at 10 Mb/s. | Back Panel |
2 blink + pause | GE port operating at 100 Mb/s. | ||
3 blink + pause | GE port operating at 1000 Mb/s. | ||
L (Link) | Green | GE link is established. | Back Panel |
Off | No GE link is established. | ||
EN (RJ-45 console port) | Green | The RJ-45 console port is active. | Back Panel |
EN (USB serial console port) | Green | The USB console port is active. | Back Panel |
ISM | Green | Initialized. | Back Panel |
Amber | Initialized with error. | ||
Off | Not installed. | ||
PVDM3 0,1,2 and 3 | Green | PVDM is initialized. | Back Panel |
Amber | PVDM is detected but not initialized. | ||
Off | No PVDM installed. | ||
SFP S | Blinking green | Blinking frequency indicates port speed. | Back Panel |
SFP EN | Off | Not present. | Back Panel |
Green | Present and enabled. | ||
Amber | Present with failure. |