10mm Front Service LED Display Waterproof Front Maintenance LED Screen

Pixel specification: 1RGB

LED specification: SMD3535

Pixel pitch: 10 mm

Resolution: 10000 point / ㎡

Module size: 320 * 160 * 190 mm

Module Weight: 500±10g

scan:1/2

Brightness: >7500 CD / ㎡

Maximum power consumption:850 w / ㎡

Waterproof level: IP65

Use life: 100000 hours or more

Gray level: 8 bit - 16 bit adjustable, the factory standard 14 bit/recommend 4096 level

Visual Angle: level: 90 ℃ - 120 ℃

Control mode: computer synchronous control

The environment temperature: storage: - 40 ℃ to + 85 ℃ : operation: - 20 ℃ - + 80 ℃

Environmental humidity: 10% 90%

Refresh frequency: more than 1000 hz adjustable

Pixel is out of control rate: < 0.0001 (LED industry standard: less than three over ten thousand)

Supply mode: AC220V / 50 hz or AC110V / 60 hz

Packing Specifications: 78.5*38*38.5cm/50pcs/26kg

Description:

1. Both front and rear service:

For some special application, front service is a must. BAKO makes new design for SMD outdoor LED display. Modules, fans, powers and receivers can all be taken out from the front. This can save much space.

2. Good waterproof protection:

Front is IP65 and back is IP54. There is totally no problem for outdoor application.

3. Big view angle:

SMD view angle is bigger than DIP.Its view angle is 160°for horizontal and 110°for vertical.

4. Good color uniformity:

Since 3 LED chips are encapsulated in one lamp, SMD color uniformity is much better than DIP so the showing effect is perfect.

5. Anti-low temperature:

for very cold areas such as Russian market, we should pay special attention to the cold temperature. So we will use anti-low temperature power suppliers and special heat system to warm the display.

6. Good heat output system for high temperature:

For hot ares, heat output system is specially important. Or else, the whole display will become hot and there will be dangerous. So we help clients to reduce current and also make add fans for screen.

7. Energy saving:

power consumption is a key factor for LED billboard. BAKO’s LED display is designed with low power consumption to help clients to save energy.

8. High brightness:

For outdoor application, brightness is important, especially if the LED display faces the sun directly. BAKO’s outdoor display brightness can be above 7500 nits, completely ensure the requirement for outdoor application.

9. Adjustable brightness:

In the daytime, brightness should be high. But in the evening, it should be reduced for traffic safety. BAKO’s LED display can make the brightness adjusted automatically. Also, this method can help to save much energy.