Product Description
A typical ultra pure water or high purity lab water system has three stages: a pretreatment stage to produce purified water, a primary stage to further purify the water, and a polishing stage which is the most expensive part of the treatment process.
The polishing stage is used to purify and super-purify the residual ions after membrane removal, so that the ion content in water was reduced to trace level. Ultrafiltration, UV and other technologies are used to ensure that microorganisms, organic substance and pyrogens in ultra-pure water to meet the needs of various experimental applications.
Technical Parameter
Type | Comprehensive Analytical Type |
Model | OK-EP60VF |
AC Voltage | 110/220V,50/60Hz |
Flow Rate | 1.5-2L/min |
Output | 60L/h |
Feed Water Requirements | Tap water, temperature 10~35℃,pressure 0.15-0.35Mpa;TDS:≤200mg/L |
Water Quality | |
Type 2 Pure Water | Conductivity:2-10μs/cm@25℃ |
Type 1 Ultra-pure Water | Resistivity:18.25MΩ/cm@25℃, TOC:<5ppb, Bacteria: <1CFU/ml, Particle: (>0.2μm) <1pc/ml |
If UV or Not | Yes.UV lamp to get rid of bacterial spores |
If Ultrafiltration or Not | Yes.Ultrafiltration to pyrogen removal |
Application | Molecular biology, life science, gene research, tissue culture, test tube baby, bioengineering, animal and plant cell culture, DNA, monoclonal antibody research, etc. |
Dimension(L*W*H-mm) | 500*450*750 |
Weight(kg) | 70 |
Consumable Cartridge | Including a standard cartridge PP filter, activated carbon filter, |
Maintenance and Tips | Generally,change it every 6months(PP filter,actived carbon filter)and replace it when resistivity ≤ 10MΩ.CM(iox exchange column) |
*The conductivity of RO water is affected by the inlet conductivity of tap water, and the typical value is calculated with inlet water less than 300 μs.
*The TOC value of water production is directly affected by inlet conditions and the sampling operating environment.
This water system is an analytical, ASTM-type I water purification system. Through deionization, it will produce up to 2 liters per minute of ultrapure water that has a resistivity of up to 18.2 meg-ohm and TOCs of 5 ppb or less.
Laboratory Water Purifier
Type 1 Ultra Pure Water
• Applications:
• Analysis of organic and inorganic traces
• Chromatography
• Mass spectrometry
• UV-visible spectrophotometry
• Microbiology
Type 2 Pure Water
• Applications:
• Media preparation
• Preparation of buffers
• Washing and rinsing of glassware
• Preparation of chemical reagents
• Ultrafiltration equipment washing
Product Features
1. Economical and easy installation
2. 2L/ min of ASTM type I water
3. Producing both pure water and ultrapure water
4. Resistivity up to 18 meg Ω/cm
5. TOC as low as 5ppb or less
6. Connect to tap or pretreat
7. Real-time resistivity reading
8. Prompts, animations, alerts