CE Approved Support OEM Smart Parking Barrier Gate Electric Traffic Boom Barrier

Specifications

Adance Advantages

1. steady function, sensitive reaction, low noise

2.The case shell is made of thickened steel which is shaped by 13 process flow. Without

fading ,waterproofing, not rusty, durable.

3.high sensitive limit switch, pole can be instant turn on and off .accurate location.

4.control system adopts hi-tech digital chip technology.

5. the anti-collision function. Protecting the passenger

6. the inductive function ,with the digital vehicle detector

7.the movements adopts the most steady running mode –non-constant speed mode. Or

the variable speed excogitation. (Slow – quick – slow ) .This function makes the operation

steady and prolongs the working life.

Model Selection and Differences

Communication with customers

1)Q: Connected power and press open/close button but traffic barrier gate no action?

A: It may be Fuse Blown, You can check fuse and power in controller.

B:It may be battery of remote control powered off, you can change another new one.

C:It may be External protection circuit break or at protecting status. you can open the barrier

door and click OPEN/CLOSE button on control box.

D:It may be same frequency interference, you can check the photocell and loop detector.

2) Q:Connected power and press open/close button,traffic barrier gate will move but

even when it is at right position, the motor still running and not stop?

A:maybe the reason is the limit switch,you can adjust the horizontal/vertical limit switch to correct

position

B:maybe the reason is the main controller failure, you can change a new one.

3)Q: Motor running but traffic barrier gate arm no action?

A:When the barrier arm at 45°position where is hard to move, you can unlock clutch and

manually rotate arm to horizontal or vertical position then try again.

B:Tension of balancing spring not suitablle, you can adjust spring exactly.

C:Low working voltage, you can check the voltage and power.

4)Q: When opening/closing,traffic barrier gate arm cannot reach right position (90°

vertical & 180° horizontal)?

A:Length adjustment of connecting rod not correct, you can open barrier door and unlock

clutch to check when arm at 90° vertical postion if the master rod covers slave one; when arm

at 180° horizontal position if master rod and slave one are in the same straight line.

B:Nuts on the limit switch loose, you can tighten the nuts when arm at 90° vertical and 180°

horizontal.