50A 1000V high current pinout single-phase bridge rectifiers KBPC5010W

Description

A bridge rectifier is an array of semiconductor diodes configured as a bridge that acts to change AC (alternating current) to full-wave pulsating DC (direct current). When AC current is connected across one diagonal, DC current is available across the other diagonal. The four diodes allow full-wave rectification without the need for a center-tap on the transformer.

Bride rectifiers are classified into several types based on these factors: type of supply, controlling capability, bride circuit’s configurations, etc. Bridge rectifiers are mainly classified into single and three phase rectifiers. Both these types are further classified into uncontrolled, half controlled and full controlled rectifiers.

Features:

• Metal case for maximum heat dissipation
• Surge overload ratings-400 Amperes
• Low forward voltage drop

Mechanical data:

• Case: Metal, electrically isolated
• Epoxy: UL 94V-0 rate flame retardant
• Lead: MIL-STD-202E, Method 208 guaranteed

• Polarity: As marked
• Mounting position: Any
• Weight: 30 grams

Application:

It is used in many electronic devices including laptop computers, cellular phones and PDA's. Depending on how you're viewing the electronic component.

Advantage:

The main advantage of this bridge circuit is that it does not require a special centre tapped transformer, thereby reducing its size and cost.

Maximum ratings and electrical characteristics:

Rating at 25℃ ambient temperature unless otherwise specified. Resistive or inductive load,60HZ.
For capacitive load, derate current by 20%

NOTES :

1. Measured at 1 MHZ and applied reverse voltage of 4.0 volts

2. Thermal Resistance from Junction to Case per leg.

Dimension:(mm)