Through hole 50A high current bridge rectifiers KBPC5010 single-phase

Description

A diode bridge rectifier is a device for converting AC, or alternating current electricity into DC, or direct current. AC electricity goes from positive to negative constantly, whereas DC always flows in the same direction. AC electricity is more efficient to transmit and easier to convert into different voltages, so power is transmitted from the station to your house as AC. However, most appliances need DC current to run. A diode bridge rectifier is the most common type of power supply used to provide this current.

Bride rectifiers are classified into several types based on these factors: type of supply, controlling capability, bride circuit’s configurations, etc. Bridge rectifiers are mainly classified into single and three phase rectifiers. Both these types are further classified into uncontrolled, half controlled and full controlled rectifiers.

The main advantage of this bridge circuit is that it does not require a special centre tapped transformer, thereby reducing its size and cost.

Features:

• Metal case for maximum heat dissipation
• Surge overload ratings-400 Amperes
• Low forward voltage drop

Mechanical data:

• Case: Metal, electrically isolated
• Epoxy: UL 94V-0 rate flame retardant
• Terminals: Plated .25"(6.35mm) Faston lugs, solderable per MIL-STD-202E, Method 208 guaranteed

• Polarity: As marked
• Mounting position: Any
• Weight: 30 grams

Application:

It is used in many electronic devices including laptop computers, cellular phones and PDA's. Depending on how you're viewing the electronic component

Maximum ratings and electrical characteristics:

Rating at 25℃ ambient temperature unless otherwise specified. Resistive or inductive load,60HZ.
For capacitive load, derate current by 20%

NOTES :

1. Measured at 1 MHZ and applied reverse voltage of 4.0 volts

2. Thermal Resistance from Junction to Case per leg.

Dimension:(mm)