4078 Masima OEM RD Rainbow, R25-12, SpO2 Extension Cable, 12 Ft

Description

RD Rainbow SET series patient cables are used with RDSET® series sensors. The RD Rainbow SET series patient cable is only used for equipment that contains Masima®SET® or Masima Rainbow Group® technology version 7.1 or higher or authorized to use Rainbow® compatible sensors. Consult individual oximetry system manufacturers for compatibility of specific equipment and sensor models. Each device manufacturer is responsible for determining whether their device is compatible with each sensor model. RD Rainbow SET series patient cables have been verified using Masima Rainbow SET technology. Warning: Masima sensors and cables are designed for use with MasimaSET oximeters or equipment authorized to use Masima sensors.

Warnings, precautions and instructions

• Ensure that the cable is PHiliphhilipysically intact and there are no damaged or frayed wires or damaged parts. Check the cable visually and discard if you find cracks or discoloration.

• All sensors and cables are designed to use specific monitors. Check the compatibility of monitors, cables and sensors before use, otherwise it may cause performance degradation and/or patient injury.

• Lay patient cables carefully to reduce the possibility of patient entanglement or strangulation.

• Failure to properly connect the sensor or oximeter module to the cable may result in intermittent readings, inaccurate results, or no readings.

• To avoid damaging the cable, always keep the connector instead of the cable when connecting or disconnecting both ends.

• To prevent damage, do not soak or soak the sensor or cable in any liquid solution. Do not try to sterilize cables or sensors.

• Do not try to reprocess, repair or recycle Masima sensors or patient cables, as these processes may damage electrical components and may leak

Note: Replace the cable when the message to replace the cable is displayed, or when the low SIQ message is always displayed when monitoring continuous patients after completing the low-SIQ troubleshooting steps determined in the operating manual of the monitoring equipment.

• Note: The cable provides X-Cal® technology to minimize the risk of inaccurate readings and unexpected loss of patient monitoring. The cable will provide up to 17,520 hours of patient monitoring time. When the patient monitoring time runs out, replace the cable. Some legacy monitoring equipment does not distinguish between cables and sensors. In these devices, replacement of sensors or similar information can involve sensors or cables.

illustrate

A) Connect the RD Rainbow SET series patient cable to the device

1. Connect the device connector of the patient cable to the mating connector of the device.

2. Make sure that the patient's cable connector is fully connected to the device. A tactile or audible connection clicking sound should be heard.

B) Connect the RD Rainbow Group series patient cable connector to the RDSET disposable sensor connector 1. Position the sensor connector to the patient cable connector as shown in the figure.

2. Fully insert the sensor connector into the patient cable connector until it locks into place, as shown in the figure.

C) Connect the RD Rainbow Group series patient cable connector to the RDSET reusable sensor connector 1. Direct the sensor connector to the patient cable connector,

2. Insert the sensor connector fully into the patient cable connector. Close the sensor connector cover on the patient cable connector until it locks into place.

D) Disconnect the RD Rainbow series disposable sensor connector from the RD Rainbow series patient cable connector

1Pull the sensor connector firmly to remove it from the patient cable