SonoScape Convex Array Transducer Probe C344 For the S2 Portable Ultrasound System Used in Good

►Brief Description

The Sonoscape C344 Curved Array transducer has a frequency range of 2.0 MHz. - 5.0 MHz. and supports the following applications: Abdominal. The Sonoscape C344 transducer is compatible with: Sonoscape SSI-6000; Sonoscape SSI-5000; Sonoscape SSI-4000; Sonoscape SSI-1000; Sonoscape SSI-2000BW ultrasound systems.

Definition of Cleaning

All transducers require proper care, cleaning, and handling. This section contains information and instructions to help you effectively clean, disinfect, and sterilize your transducer for use in ultrasound systems. In addition, these instructions will help you avoid damage during the cleaning, disinfection, and sterilization processes that could void your warranty.

Reasonable care includes inspection, cleaning, and, if necessary, disinfection or sterilization. The transducer must be cleaned after each use. Do not allow contaminants to dry on the transducer. You can use an enzymatic foam spray to remove dried contaminants.

Before each use, carefully inspect all parts of the transducer. Check for cracks or other damage that could compromise the integrity of the transducer. If any damage occurs, report it to your authorized service representative and discontinue use of the transducer.

► Specifications

►Cleaning and Disinfection

Clean and disinfect (or sterilize) the probe as needed after each examination. Always sterilize the needle guide stent after performing the biopsy procedure. Otherwise, the probe and needle guide holder may become a source of infection. Please refer to the cleaning instructions.

1. To prevent infection, wear sterile gloves when cleaning and disinfecting the probe.

2. If the probe is not cleaned and sterilized, it may become a source of infection.

3. After disinfection, rinse the probe thoroughly with sterile water to remove chemical residue. Chemical residue on the probe may be harmful to humans.

Note: Gently wipe off the ultrasound gel after the examination. Otherwise, the ultrasound gel may solidify and affect the image quality of the transducer.

NOTE: Do not overheat the probe (above 55°C) during cleaning and disinfection. High temperatures may deform or damage the probe.

Disinfect with a spray or wipe

1. Wear sterile gloves to prevent infection.

2. After cleaning, wipe water off the transducer with a sterile cloth or gauze.

3. Wipe any residue off the transducer with a soft cloth dampened with water.

4. After cleaning, spray or wipe the transmitter with disinfectant. Follow the contact times and methods recommended by the disinfectant manufacturer.

If you're interested in SonoScape Convex Array Transducer Probe C344 For the S2 Portable Ultrasound System Used in Good Condition ,feel free to contact us .Thank you .