0.6-1.8W 220V Capacitor Night Light PCBA Circuit Board For Exhibition Halls
Specification
Use | leisure and entertainment venues |
Increased Power | By CBB buck capacitor and current limiting resistor |
LED type | single 2835 LED beads |
Output drive type: | Without MOS |
Battery | None |
IC, MOS, thyristor, relay | No, direct 220V capacitor step-down |
Low power consumption | 0.6-1.8W |
Output load | 0.6W |
Board type | Key board |
Note: The input wattage of 220V may be inaccurate due to problems with the measuring equipment.
The voltage waveform of the voltage regulator tube, the current of the LED fluctuates with the waveform, and the increase of the aluminum electrolytic capacitor makes the waveform more stable.
Operation
Connect the power to pull the switch, connect to 220V, the light is on directly after the switch is energized, but not on after it is turned off.
Package
1. Anti-static bubble film shall be used for packaging and packing after piecing together
2. Matters needing attention when packing
1) Considering the force comprehensively, the direction set up after PCBA packing should be the same as that of corrugated carton
2) Avoid the collision between PCBas during packaging; Appropriate placement and bubble film thickness should be selected.
Shipping
1. Tracking number will be emailed to you once we have shipped your order. If there is any delay, it may be caused by bad weather or custom inspection. If you still can not receive the item within 20 DAYS, pls contact us.
2.We try our best to make you get desired products as soon as possible. In case you receive wrong products due to shipping error, please contact us for exchange or refund. If it's damaged , please refuse to accept and contact us as soon as possible.
3.We are not responsible for wrong or undeliverable address. Please provide us your full address with Telephone number and make sure your shipping address is correct and deliverable. If you need to change your address, please change it in PayPal first before you pay.