16 Amp 8 Amp DC12V SPDT Power Relay 8 Pin 1 Form C 400mW PCB Mount

SPDT solid-state relays can be divided into two types:

(1) Push-pull SPDT solid state relay The general circuit diagram of a push-pull SPDT SSR relay is shown below (shown in Figure 7).The push-pull SPDT SSR switch consists of two LEDs (D1, D2) and two Photo-TRIACs (TRIAC1, TRIAC2).D1 and TRIAC1 form CIRCUIT1, and D2 and TRIAC2 form CIRCUIT2.A push-pull signal (Gout) is generated in the input control terminal of the SPDT SSR, and LOAD1 and LOAD2 are connected to two output terminals of the SPDT SSR relay.

(2) Photodiode array type SPDT solid state relay The following shows the general circuit diagram of a photodiode array SPDT SSR relay (as shown in Figure 8), which can work in both DC and AC power sources. The photodiode array type SPDT SSR switch consists of a photodiode array (D1), and four N MOSFETs (MOS1 and MOS2 are enhancement N MOSFETs ③; MOS3 and MOS4 are depletion N MOSFETs ④).MOS1 and MOS2 form CIRCUIT1, and MOS3 and MOS4 form CIRCUIT2.There are 5 output terminals Port1, Port2, Port3, Port4, Port5, and Port1 is a common terminal.LOAD1 and LOAD2 are connected to the SPDT switch.

SPDT Power Relay Description:
WRG's RB series power relay is a high capacity, short and small, special for which have size limited. Input voltage has 3V/5V/6V/9V/12/18V/
24VDC for options, and with a range current from 4A to 20A, can meet different requirements from users.CQC,TUV,UL,VDE certification,
IEC 60079-15 anti-explosion standard, good performance, and quality of products are guaranteed.

SPDT Power Relay Feature:
1. Rated current 8A/16A
2. 8pins,5.0mm pitch
3. TV load is available
4. Class F coil insulation
5. Meet with IEC 60079-15 anti-explosion standard
6. 5KV for dielectric strength between coil and contact

SPDT Power Relay Specification:

For further datasheets, please click the link below or contact us.
RB Series.pdf