RS485 Interface Electrical Isolation PH Probe For Industrial Process Measuring

PH digital sensor can directly output RS485 signal and 4-20mA signal; the product has good accuracy, good stability and strong anti-interference ability. Automatic temperature compensation function.

Without the need for instruments, it can be directly connected to computers, PLCs and other equipment with RS485/4-20mA signal interfaces for data collection and maintenance; it is convenient for users to integrate sensors into the host computer system and the Internet of Things and other industrial control environments.

The sensor can be set through RS485 communication, such as slave address and baud rate, online calibration, factory reset, 4-20mA output corresponding range (4-20mA is optional), proportional coefficient and incremental compensation. A two-point calibration method was used. Power failure protection>10 years.

Specification:

Please click the user manual of RS485 pH sensor here:
DPH7 digital pH User Manual.pdf

Features＆ Advantages

● All-in-one package, can be used with the online transmitters, DTU, and portable instruments
● RS485 interface, Modbus RTU, support access to standard industrial control system
● The protection grade is IP68, can work continuously and stably under water for a long time
● Internal storage of calibration data, support offline calibration, plug and play on site



Aplication:
Water treatment monitoring
Drinking water,surface water,water quality analyze,ground water,ect.

Industrial process monitoring and dosing control
Chemical,petroleum,paper,food and medicine,PCB manufacturing,etc.

FAQ
1. What is the measurement principle of this pH electrode?
A: The pH value potentiometric method uses the potential difference of glass electrodes for pH measurement.

2. How to judge the pH of the solution?
A: If the internal hydrogen ion concentration of the pH glass bulb is lower than the outside, the measured solution is recorded as acidic and the pH value is lower than 7; if the two are the same, the solution is neutral and the pH value is equal to 7; if the internal hydrogen ion concentration is higher than externally, the measured solution is alkaline and the pH value is higher than 7.

3. What is the wire length of the pH electrode?
A: The lead wire of this electrode is 1 m by default, other lengths need to be customized, contact our customer service, the price will vary with the change of length.