PE PP Sheet/Plate Extrusion Line for Heat Shrinkable Tape Heat Shrinkable Sleeve and Electrofusion Sleeve

More than 15 years of production experience
The organizer of the National Symposium on the Production and Application of Electro-fusion welding belt
Recipient of utility model patent for electric fusion sleeve
Exporting the electro-fusion welding tape to Turkey, Sudan, UAE, Japan, Russia, Kazakhstan and other countries with good feedback.


INTRODUCTION
The sheet extrusion lines are the most complete, high performance, reliable sheet lines. We offer them as complete systems in 3 sizes: With a 65mm, 90mm, or 120mm extruder, to produce just the capacity you need.

The single screw extruder with good motor, digital controls, vacuum venting, screen changer, gear box, and a flexible lip die. Your extruder also can be equipped with the PLC/PCC control system, the specially design screw for HIPS, PP, and PET.

Three rolls calender feature three hard surface polishing rolls with flawless mirror chrome plating, designed for the highest efficiency heat transfer. Each roll is equipped with an individual, built-in, high volume pressurized water temperature control system. The line also includes two shaft winder.


Electrofusion mesh:

Material and composition: The electrofusion mesh is made of nickel and chromium thin-walled stainless steel plates by high-pressure punching. and the composition of the stainless steel plate meets the following requirements

Performance:
1. Adopt high-quality raw material: HDPE 2480 produced by China Petroleum &Chemical Corporation and High-temperature resistance nicochrome net.
2. The tape/sheet is fully fused with the pipe after electric heating with good sealing effect, corrosion resistance, and long life service.
3.Able to withstand axial forces initiated by axial movements of the pipe in the ground;
4.Able to withstand radial forces and bending moments;
5. Able to withstand the effects of temperature and temperature variations.

Size and deviation of the electrofusion mesh

Resistivity of electrofusion mesh should comply with the following standard

Resistivity of electrofusion mesh