Electric Pipe Beveling Machine

Product Introduction

Inner mounted pipe beveling machines can be tightened to the internal wall of the pipe end, drive the cutter head to rotate through multi-stage planetary reducer and then bevel small-diameter pipes. The applicable inside diameter of pipes for our pipe beveling machine is up to 240 mm (if the pipe to be beveled is larger than this scope, please choose our split frame machines).

Features

■ Portability: Our BPP series are packed with suitcase, which is convenient for carrying and allows you to finish processing outdoors.

■ Quick installation: After being taken out from the suitcase, the machine will be ready only by positioning it at the center of the pipe through the ratchet wrench and equipping it with a suitable cutter. The process will not exceed 3 minutes. The machine will start to work after pressing down the motor button.

■ Safety and reliability: Through multi-stage deceleration by the internal bevel gear of the angle grinder, the planetary reducer and the internal bevel gear of the main shell, the machines can operate under slow rotating speed while keeping large torque, which makes the beveled end smooth and flat and in high quality, and extends the service of the cutter.

Technical Parameters

Tools

The tools attached to the products upon delivery are all made of high-speed steel and applicable to process all types of carbon steel. Their types are the five tools in the above diagram.

Installation & Processing

■ During installation, the tools should not touch the feed spindle and the expansion block.

■ The expansion block should not be stretched too deep into the pipe and keep about 20 mm from the pipe end face.

■ During processing, control the feed speed based on cutting conditions to avoid damage of blades and parts in the machine; In case of vibration of the machine or uneven bevel face, timely tighten the expansion hand wheel to prevent the looseness of the expansion, which may cause damages to the machine.

During installation, the tools should not touch the feed spindle and the expansion block.

■ The expansion block should not be stretched too deep into the pipe and keep about 20 mm from the pipe end face.

■ During processing, control the feed speed based on cutting conditions to avoid damage of blades and parts in the machine; In case of vibration of the machine or uneven bevel face, timely tighten the expansion hand wheel to prevent the looseness of the expansion, which may cause damages to the machine.

Safety Instructions

Product package

Our BPP series machines are delivered together with fitting instruments, various models of cutters, various types of expansion blocks and the operation manual, and packed in a portable suitcase. For other requirements, please contact our company in advance and we will provide other configuration based on your requirements.