Portable Hand Held Electric Pipe Beveling Machine for Mechanical Pipe Edge Preparation

Product Introduction

Our portable handheld pipe beveling machines for mechanical pipe edge preparation and orbital welding makes the job easy to be done on-site or in the workshop. The pipe beveling machine is fixed on the workpiece with an inside or outside clamping mechanism. It's designed for simultaneous facing and beveling tubes and pipes (including carbon steel, alloy steel and stainless steel) from 12.5mm to 240mm I.D. up to a wall thickness of 0.75" (18mm).

Application Industries

■ Energy Field

Oil Refinery

Offshore Engineering

Power Plant

■ Process Engineering

Electronic Equipment

Medicine

Biotechnology

Food and Beverage Industry

■ Construction and Construction Equipment

Water and Gas

Water and Treatment

Heater

Basic Info.

*Electric: Rated voltage of 220V, 50/60Hz

Advantages:

• High cutting capacity
• Quick and secure clamping
• Rugged and compact construction
• Easy handling

Installation & Processing

■ Measure the inside diameters of the pipe to be processed and choose a suitable machine and expansion block.

■ Select the appropriate block, place it on the bottom of the expansion block to ensure the top surface of the expansion block remain horizontal without any inclination, and rotate the sleeve anticlockwise to tighten the expansion block and, ensure that the machine is firmly fixed in the pipeline.

■ Choose a tool with suitable angle listed in the tool table based on the processing requirements, install it on the cutter head of the machine and tighten the bolts to fix the tools.

■ Rotate the feed hand wheel and extend the feed spindle Loosen screw and feed.

■ Stretch the machine expansion mechanism into the pipe, and reserve sufficient feed space between the tool on the cutter head and the pipe end face.

■ Rotate the expansion sleeve with the ratchet wrench while adjusting the position of the machine to ensure the feed spindle and the center of the pipe is concentric; Tighten nuts on the expansion sleeve with the ratchet wrench after determining the position.

■ Start the motor. Rotate the feed handwheel to make the cutting edge contact with the pipe wall, and then bevel.