Automatic LDPE/LLDPE/PE grinding pulverizer machine with disc mill blades

Plastic pulverizer machine introduction:

Suitable for PVC, PE, PET recycled materials. It is used for fine grinding of various plastics, especially for processing and grinding thermoplastic PVC PE plastic recycled materials. According to the practice of the professional factory of plastic products, the grinding powder is added in the processing formula by 20%-30%, and the chemical and physical properties of the products remain unchanged. Therefore, it is the best equipment for plastic products factory to reduce the accumulation of waste products....

Plastic pulverizer machine performance characteristics:

●The new grinding disc design has high output, strong wear resistance and twice the service life of ordinary grinding discs.
●High speed achieved with newly designed special bearings
● Easy installation and maintenance, the door cover can be cleaned, and the fan discharge reduces the labor intensity of the operator.

● Increased dust collection device, effectively reducing dust pollution, completely sealed during grinding, no dust leakage
● Fully automated, automatic feeding, discharging, sorting
●The adjustment of the grinding gap is simple and can be precisely adjusted by using the feeler gauge and adjusting bolts.
●The main engine cooling system is cooled by wind and water. It is cooled by feng shui, which lowers the working temperature inside the machine. The material is not easy to change color, and it is also beneficial to the grinding of heat sensitive plastic. It can be used for some PE and EVA. , SBS, ABS grinding
● Reasonable design, small cross section of the grinding cavity, the material will be caught and ground immediately as soon as it enters, and it will be removed quickly, avoiding the temperature rise and decomposition of the material, thus achieving higher output.

Details specification pictures of Plastic pulverizer:

Technical dates of Plastic pulverizer:

A1:PP/EVA/ABS pulverizer

A2:HDPE/LLDPE /soft PVC/PET etc pulverizer

A3:Hard PVC pulverizer:

Plastic mill safety matters:

Familiar with the contents of the manual and the function of the electrical button, the direction of rotation of the main unit must conform to the direction of the arrow marked on the belt cover.

Start the fan before starting the machine (pay attention to the steering). After the normal operation, start the main machine to reach the normal speed and start feeding.

At the beginning of production, the valve opening of the feeding port should be small, as long as the material can come out, then slowly open the damper cover. After the material enters the machine, the load condition of the machine is generally around 68A, which is measured by the ammeter on the electric control panel. The 37KW 4KW is parallel, so its total current value is 70A. During normal operation, the current should be between 65-70A and swing.

Material selection requirements: The maximum diameter of the material particles should not exceed 15mm. Do not accidentally enter the machine into the machine, so as to avoid intensifying the wear and damage of the blade and fixing the knife.

If there is abnormal sound during operation, stop immediately, open the door cover to check, and then continue production after the exclusion.

Plastic mill maintenance:

1 Open the door cover regularly, check the blade fastening nut, whether the cover and nut are loose, and tighten if loose.

2 Lubrication: The use of lithium-based disulfide (MoS2) grease for the main bearing

3 Fans and ducts shall inspect their blades and inner walls of the pipes and remove the dust from their knots.

4. After the blade has been used for a considerable period of time, the surface of the blade is ground to a larger radius.

Remove the blade splint and turn the blade 180 degrees. After tightening, continue to use.