1/2inch Brass hot forging filter with filter function vertical check valve , Water pipe connect using

Specification:

Working pressure 16 bar (232 psi)
Working temperature from -10℃ to +120℃(from 14°F to 248°F)
Thread ISO228 (equivalent to DIN 259 and BS2779)
Suitable for hot and cold water,oils and domestic water service.

Main technical parameters:

1.We select high quality copper material and apply hot forging process in the production process.

2.The main working medium are water,oil.gas.etc.

3.Working temperature range from -20℃ to 100℃

4.Thread standard:ISO228

Each nominal working pressure of our gate valve are 2.5Mpa,2.0Mpa and 1.6Mpa

Materials:

Body:Brass inernal seat:stainless steel plate 304AISI fitted with BBR ,Cover plate and rod in brass

Working temperatures:

Air:-20℃ to 110℃

Water:0℃ to 90℃

Gas:-20℃ to 60℃

Applications:

Can be fitted in horizontal,vertical or oblique position,suitable for hot/cold water,compressed air,oils.

Quality control:

We do strictly control measurement on finish products and do our best to saitisfy our customers.

-Metal analyse instrument

-Pressure test instrument

-Tensile strength instrument

We Promise:

1)Quotation cycle:1-2 working days

2)Development cycle:20-30 working days for new Item.

3)Production cycle:25-45 days

4)Full-inspection of products,guarantee for 3-5 years

Installation instructions:

For pipe thread connection type check valve,we should make sure the pipe being vertical against the surface of the valve body when tighten the connection part. our special warning is that we should only wrench the octagonal at the same end of body instead of the other side to avoid deformation so as to affect its normal open function.
For internal thread type check valve,we should control the lread at the pipe end in case deformation of the valve body.caused by the external thread’s aqueezing the surface of the internal thread so as to affect leakproofness
When connecting the pipe thread type check valve with pipe thread,the internal thread can be either tapered pipe thread or cylindrical pipe thread,but the external thread must be tapered pipe thread,otherwise it will cause leakage due to loose connection.
When installing the pipe thread type check valve,the sealing material must be clean
Such obstacles as wall coupling nut and pipe should not be placed inside the open/close range
When the check valve handle is parallel to the body,it is open,otherwise,it is close
The working medium should not contain particles ,corrosive gas or liquid