Low Power Control Solenoid Valve Part -200 To 200 Temperature Range Solenoid Stem

Application for Dust-removing solenoid valve

1.After assembling with solenoid coil and solenoi stem.

2.Dust-removing solenoid valve:The dust collector solenoid valve is a compressed air switch for the dust removal system of the pulse bag filter. Controlled by the output signal of the pulse injection controller, the filter bag is injected one by one and the resistance of the dust collector is kept within a set range

to clean the dust to ensure the processing capacity and efficiency of the dust collector

Work principle

The diaphragm divides the pulse solenoid valve into two chambers. When the compressed air is switched on, the compressed air enters the back chamber through the throttle hole. At this time, the pressure of the back chamber will press the diaphragm to close the output port of the valve, and the pulse solenoid valve is in a "closed" state. The electric signal of the pulse injection controller makes the armature of the pulse solenoid valve move, the vent of the back chamber of the valve opens,then the back chamber loses pressure rapidly and the diaphragm moves backward, the compressed air is injected through the outlet of the valve, and the pulse solenoid valve is in the "open" state. The electric signal of pulse jet control device vanishes and the armature of pulse solenoid valve is reset. The outlet of the back chamber is closed, and the pressure of the back chamber rises to make the diaphragm close to the valve outlet, and the pulse solenoid valve is in the "closed" state.

Detail information/demension instruction

1.Brand:BRANDO

2.NO.BAPC214041405

3.Voltage:Both AC/DC

4.Tube OD:14.0mm

5.Tube height:41.4mm

6.Item weight:82g

7.Movable core height:32.3mm

8.Connection type:Groove and male thread

9.Seal material:NBR

NBR:NBR has good resistance to mineral oils, vegetable oils, benzene/petrol, ordinary diluted acids and alkaline.

10.Depth:30.6mm

11.Temperature:-200 to 200

12.Pressure:Normal

13.Test with three inspectors

We have very strict quality control,each item we manufacuture will be testd by different aspects.Such as pressure test,temperature test,corrosion-resistance test,toxic-resistance test,voltage test,etc

Items can be customized and make OEM if you have the sample and drawing

Contact us by email is ok,We will reply your email and fox within 24 hours .

Pay attention to

Related solenoid stem

Note

If you have some special requirements and requests.Inform us and give you a best solutin

All the items' specification can be customized