Double Acting Pneumatic Air Cylinder Airtac Type SC63x100

Pneumatic cylinders, commonly known as air cylinders or air rams, move a load in a straight line using a piston rod. Compressed air either pushes or pulls the piston rod in and out of the cylinder barrel.

Single-acting cylinders use one compressed air port to either push or pull the rod in a single direction. The rod then returns via spring action. Double-acting cylinders use compressed air ports on both ends of the cylinder to extend and retract the rod. Certain series of Airtac cylinders come with cushions, which allows for quieter piston operation. Most air cylinders have several different mounting types available.

Specifications of SC Series Pneumatic Cylinder:

Stroke of SC Series Pneumatic Cylinder:

Symbol of SC Series Pneumatic Cylinder:



Ordering Code of SC Series Pneumatic Cylinder:


Criteria for selection: Cylinder thrust:


Installation & Usage:
1. When load changes in the work, the cylinder with abundant output capacity shall be ed.
2.Relative cylinder with high temperature resistance or corrosion resistance shall be chosen under the condition of high temperature or corrosion.
3.Necessary protection measure shall be taken in the environment with higher humidity, much dust or water drops, oil dust and welding dregs.
4.Dirty substances in the pipe must be eliminated before cylinder is connected with pipeline to prevent the entrance of particles into the cylinder.
5.The medium used by cylinder shall be filtered to 40μm or below.
6.Anti-freezing measure shall be adopted under low temperature environment to prevent moisture freezing.
7.The cylinder shall be carried out test run without load before application. Prior to run, buffer shall be turned to the minimum and gradually released to avoid the damage on cylinder caused by excessive impact.
8.The cylinder shall avoid the influence of side load in operation to maintain the normal work of cylinder and extend the service life.
9. If the cylinder is dismantled and stored for a long time, please conduct anti-rust treatment to the surface. Anti-dust caps shall be added in air inlet and outlet ports.

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing

Welcome to your any question and inquiry!