Air Working Medium ASCO Submerged Type Pneumatic Pulse Valve QK25 with Port Size 1 Inch
About the classical ASCO submerged type Pulse Valve,the pulse valve input end (IN) is connected to the metal tube of the gas storage cylinder, and the output end thereof is connected with the dust blowing box blowing pipe, and the connecting thread is filled with the tetrafluoroethylene raw material tape to be tightly sealed.The Y-type pulse valve is a submerged valve (also known as an embedded valve) that is mounted directly on the air bag for better flow characteristics.
The pressure loss has been reduced, which is suitable for workplaces with low air supply pressure.This type Pulse Valve are instock,If you are interesting,pls contact us without any hesiratioln.
Model No. | QK25 |
Working Pressure | 0.3-0.8mpa’ |
Environment Temperature | -5~55℃ |
Relative Humidity | 〈85% |
Working Medium | Clean Air |
Voltage | AC110 AC220 DC24V |
Diaphragm Usage | Injection more than 1 million |
Other Specifications Can be Available

Detailed Datas as Follwos for Reference

Whole Set of Bag Dust Filter System Supply

The Usage of Pneumatic Pulse Valve :
The electromagnetic pulse valve (also known as the diaphragm valve) is the compressed air "switch" of the pulse bag type dust collector cleaning system. Controlled by the output signal of the pulse controller, the filter bag is sprayed and cleaned row by row (room), so that the resistance of the dust collector is kept within the set range to ensure the dust collector Processing capacity and dust collection efficiency.
The Z-type pulse valve is a right-angle valve with an angle of 90° between the inlet and outlet. It is suitable for the installation link between the air bag and the blow pipe. The air flow is unobstructed and can provide the required cleaning gas pulse.
The Y-type pulse valve is a submerged valve (also known as an embedded valve) that is mounted directly on the air bag for better flow characteristics. The pressure loss has been reduced, which is suitable for workplaces with low air supply pressure.
Preventive Maintenance of Solenoid Valve:
Keep the medium flowing through the pulse valve as smoothly as possible to prevent dust and foreign matter from entering In use, the valve should be run at least once a month to ensure normal opening and closing;
Depending on the medium and operating conditions, it is recommended to periodically check the internal parts of the valve for damage, or excessive wear, thoroughly clean all parts (all valves should be cleaned regularly, the cleaning interval varies according to the medium and operating conditions, in general, If the voltage applied to the coil is correct, then running hysteresis, noise, or excessive leakage indicates that cleaning is required. In extreme cases, valve operation may occur, or the valve may not open and close. When cleaning the valve, it should be cleaned at the same time. Filter or filter)
If you want to know more,pls contact us at once