NBSANMINSE SRYZ 2.0Mpa Thin Oil Lubrication Pump AC380V AC220V With Overflow Valve Pressure switch Controller

Performance and characteristics

. Specific work pressure : Sets the overflow valve, To prevent oil pump overload.

. With unloading function : can stop working after removing the oil pressure in the system, mainly used in the quantitative type (pressure type or Pressure relief type) the thin oil lubrication oil supply system.

. Equipped with a hydraulic switch (closed with lack of oil 10W/DC100V/0.5A), but will output oil tank shortage signal

. Inside the pump with pressure switch (normally open AC220V/2ADC36V/2A), to monitor the lubrication system that the main oil line block and the pressure loss (optional parts)

. Inside the pump can match the PC-2 display controller, control the operation tie and off tie (optional parts)

. Transparent resin oil tank or metal oil tank

. Use the lubricant viscosity : 32~2500cst

. Assort distributor : Pressure or pressure relief type thin oil distributor

Attention

. Pressure switch as much as possible installed at the end of the system main pipe, not within the oil pump, it can more correctly detected the lubrication system condition with main pipe blocks the flow and pressure loss

.If the host with PLC, should by the host PLC control oil pump run tie and rest tie, the oil pump without set controller; But if the host does not PLC or with PLC wiring is not convenient, the oil pump shall set the controller to the countdown control lubrication pump working cycle : run time and rest time.

. If the working power supply is not AC380V 50Hz, should indicate the power and HZ when order power supply

. RYZ series pump as an example illustrates the specific technical parameters, it is same technical parameter with a pressure switch or controller with same specification.

. Example: the rated flow 0.5L/min, oil capacity 4.0L, Rated pressure 2.0MPa, the working power supply is AC380V50Hz, without pressure switch and controller of RYZ series thin oil pump models for RYZ-1; lubrication pump with a pressure switch (optional), type of RYZ-1P; lubrication pump with a controller (optional), type of RYZ-1C; If the work is specific power requirement, when you order it should indicate the voltage and frequency, such as RYZ-1/460V60Hz