EN 1492-2 Endless Polyester Round Slings , Flexible Soft Round Lifting Sling Safety Factor 7:1

Capacity
The sling must be both long enough and strong enough for the load and the slinging method. Apply the mode factorfor the slinging method. For use at temperatures exceeding 80°C or below 0°C refer to the suppliers instructions. Ifthe slings are used in multi-leg arrangement the angle formed between the legs should not be less than 30° orgreater than 90°. If abrasion, heat generated by friction or cutting from edges or corners are likely, select a slingfitted with protective sleeves and/or use suitable packing.


In-service Inspection, Maintenance and Replacement

Inspect slings each day before use, looking for:

• Missing or unreadable ID tag
• Melted, charred or weld-splattered areas
• Acid or alkali burns
• Holes, tears, cuts, snags or embedded particles
• Broken or worn stitching
• Excessive abrasive wear or elongation
• Knots or brittle areas
• Broken, corroded, pitted distorted fittings

Do not use worn or damaged slings or attachments. Discard or repair them. Use damaged slings only after they are repaired, reconditioned, and proof tested by the sling manufacturer or a qualified person. Keep certificates of proof test.

Maintenance requirements are minimal. Belt slings may be cleaned with clear water. Remember weak chemical
solutions will become increasingly stronger by evaporation. Regularly inspect belt slings and, in the event of the
following defects, refer the sling to a Competent Person for thorough examination: illegible markings; damaged,
chaffed or cut webbing; damaged or loose stitching; heat damage; burns; chemical damage; solar degradation;
damaged or deformed end fittings.