0.0762mm Narrow Gap Coating Die Series Produce For Thin Coating

Descriptions :

Narrow gap coating die head can produce a very thin coating and transparent optical coatings, also can make the coating is kept in very exact tolerances range. Unlike the wipe liquid coating on the based material, this narrow gap coating die head system belongs to die lip gap is opposite bigger (0.0762mm) coating die head, so that the thinnest coating will reach to 1um through out the die lip. On the case of the condition thickness only in 0.002mm or 2um, the narrow gap coating die head system can control the coating thickness and width. Coating thickness from less than 1um to 254um. The die head can processing all kinds of adhesive (including special transparent adhesives), battery, ceramic capacitor, decorative surface, electronic display medium, the filtration membrane, floor, fuel cells, magnetic mud, medical products, light resistance material, pressure sensitive adhesive tape, solar battery, superconductor, tore belt and the window with film etc.

• Extrusion Die Repair Upgraded

We will provide you a whole set standard service with general maintenance, die clean, examination, repair, upgrade, renovate and so on. After renovates the die, it can achieve or very close to the initial standard. Every need to repair the die we will strictly according to the following steps :

1. Die remove, cleaning.

2. Inspection, evaluation and communicate with customer requirements for renovation.

3. Faded except the original chromium plating.

4. Repair damaged surface defects or change the defects in design.

5. Replace damaged parts.

6. Repairing mold body joints.

7. The mold flow channel to polish.

8. Reassemble the die.

9. Proofreading technical specification.