Rack type network surge protective device can protect 16 network cables

Model: Trss-rj11 / 45

colour:white

Authentication: CE ECM

Brief introduction

TRSS-RJ45/8 type network lightning arrester is suitable for multiple network signal line centralized protection. It is mainly used for lightning (over voltage) protection along network signal lines, such as 8, 16 and 24 Ethernet switches. In view of the characteristics of the network system, the selection of high quality and low capacitance gas discharge tube, TVS and other devices has the advantages of small insertion loss, fast response speed, accurate clamping, low output pressure and so on.

Working principle of product

The working principle of network lightning arrester is to present high resistance open state with a low voltage, low resistance short circuit state at high pressure, and a combination of over voltage protection electronic devices which can withstand hundreds of amperes and large current in parallel on power supply line and signal transmission line. When encountering lightning and high voltage and high current, it will appear short circuit immediately, and at the same time, the total power switch will be disconnected, so that the computer equipment will be protected.

The lightning arrester can effectively protect the power equipment. Once the abnormal voltage appears, the lightning arrester will play a protective role. When the protected device is running under normal working voltage, the arrester will not work, and it will be regarded as a circuit for the ground. Once the high voltage is present and the insulation of the protected equipment is endangered, the lightning arrester acts immediately and leads the high voltage impact current to the earth, thus limiting the amplitude of the voltage and protecting the insulation of the electrical equipment. When the overvoltage is gone, the arrester is restored to its original state quickly, so that the system can supply electricity normally. The main function of the lightning arrester is to reduce the voltage value of the protected equipment through the action of parallel discharge gap or nonlinear resistance, and to reduce the voltage value of the protected equipment, so as to protect the power equipment.

Product features

1. extremely low online resistances reduce unnecessary attenuation of signal intensity and increase the distance of signal transmission to the maximum.

2. the product has many interfaces and is easy to use. It doesn't need to worry about the number of interfaces.

3. transmission distance is long and maximum transmission distance is 100m.

4. metal shielding layer, to prevent electromagnetic interference, so that the signal is more stable.

Product specification

Use of attention

1. lightning protector's input port (IN) is connected to the signal channel, and the output terminal (OUT) is connected with the input end of the protected device, so it cannot be connected to the reverse side.

2. please choose the network switch lightning protector which is the same as the protected device's interface type.

3. lightning protection device IN as input and OUT as output, the input end is connected with the outside, and the output end of the input end of the connecting device is protected.

4. this product needs no special maintenance. The lightning arrester should be checked regularly, especially in the thunderstorm season and the whole thunderstorm period. When the system fails to doubt the lightning arrester, the lightning arrester can be dismantled and rechecked. If the system is restored to normal after the restoration to the state before use, it indicates that the lightning arrester has been damaged and must be replaced immediately.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.

Ltd is committed to meeting the requirements of the European Union’s Waste Electrical and Electronic Equipment (WEEE) directive. This directive requires producers of electrical and electronic equipment to finance the take-back for re-use or recycling of their products placed on the EU market after 2005.