Product Details

The FL10 interface lightning protector is a design of lightning protection applied to the antenna feeder system based on the relevant standards. It is suitable for the satellite wireless communication, the mobile base station, the microwave communication, the radio and television and other coaxial feeder system signals, which have beautiful appearance, easy installation, easy maintenance, impact resistance and corrosion resistance. It can work in a relatively bad environment for a long time. It is an ideal protective device for all kinds of communication equipment.

Working principle of product

The lightning protection device is based on the principle of standing wave antenna and lightning wave spectrum design. The main part is a short rod equivalent to the end of the 1/4 wavelength. When the signal is sent out, a part of the impedance is reflected back because the impedance is not fully matched, and the wave will form a standing wave when the wave is superimposed on the incident wave originally emitted. The amplitude of standing wave at each point of the line is fixed first. For the transmission line with terminal short circuit, the terminal is short circuited, so the current is large and the voltage is small. For the signal end, the voltage and the current are small.
That is, the most close to the open circuit of the signal terminal impedance, so the loss is small, but for the lightning wave because of its wide spectrum range, and most of the energy is concentrated in the frequency band below 10HZ, so the short circuit rod is short circuited to the lightning, and will not invade the equipment to cause damage.

Product features

1. built in fast semiconductor protection device, with fast response speed.

2. the low attenuation coefficient ensures that the lightning arrester does not affect the system performance.

3. built in replaceable gas discharge tube, easy installation and maintenance.

Product specification

Use of attention

1.The side of the lightning arrester has a earthing screw ring, which can be inserted in a thick copper wire and pressed hard and pressed with the tigers forceps. Then the other end of the copper wire is connected to the roof of the building. The contact must be sufficient.

2. in order to reliably prevent thunder and lightning, we can connect each antenna output terminal and the input terminal of the protected device to a lightning feeder. In areas where lightning is less, only one antenna can be used without amplifier.

3. please recognize the interface and the way of connection.

4. the product is FL10 type interface, which is not suitable for other interfaces.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.