220V power supply, lightning protection, 1P surge protection, primary household power protection.

Product introduction

Surge protector lightning protector is used to protect sensitive lines from lightning induction voltage, power grid voltage fluctuation, electrostatic discharge and surge voltage caused by large load start-up. It is widely used in family housing, third industry and industrial field.

Product features

1. alarm indicating device, normal (green), red (fault).

2. leakage current is small, the response time is fast, and the residual pressure is low

3. fastening slideway buckle design is very difficult to fall off

4. troubleshooting automatic reset

Product specification

Notice of product

1. standard RJ45 interface can be conveniently connected to the front end of the protected equipment. The grounding path should be as short as possible, and the length should not exceed 1.5 meters.

2. lightning arresters are connected in series between protected equipment

3. connect the grounding wire of the lightning protector with the ground wire of the lightning protection system.

4. ambient air temperature is no more than +40 C and no less than -5 C, and the average value of 24 hours is no more than +35 C.

Structure and Principle

SPD is a port, shocking protection, indoor-mounted installation, voltage-limited.

SPD hold disconnector inside, when SPD breakdown failure by over heating, the disconnector can remove from the power grid automatically, and show indication signal. When SPD is working properly, visible window display green, it display red when it breakdown and disconnect.

1P+N,2P+N,3P+N SPD consist of 1P,2P,3P SPD+NPE zero ground protection module, apply to TN-S, TN-C-S and other power supply system.

Working principle of product

The lightning arrester can effectively protect the power equipment. Once the abnormal voltage appears, the lightning arrester will play a protective role.
When the protected device is running under normal working voltage, the arrester will not work, and it will be regarded as a circuit for the ground. Once the high voltage is present and the insulation of the protected equipment is endangered, the lightning arrester acts immediately and leads the high voltage impact current to the earth, thus limiting the amplitude of the voltage and protecting the insulation of the electrical equipment. When the overvoltage is gone, the arrester is restored to its original state quickly, so that the system can supply electricity normally.
The main function of the lightning arrester is to reduce the voltage value of the protected equipment through the action of parallel discharge gap or nonlinear resistance, and to reduce the voltage value of the protected equipment, so as to protect the power equipment.

Company profile

Thor is all about protecting against the damaging effects of power transients. It is our goal and mission to connect our customer challenges with high-quality, right-priced solutions and products – completed by unrivaled customer service and technical support.
Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built everything to offer a wide range of innovative and reliable surge protection solutions and products.