Power lightning protection module group lightning protector SPD surge protector household

Product introduction

Surge protector is a lightning protection measure adopted by Zhejiang toer Electric Co., Ltd. for electrical system. It is used to protect the lightning protection device of home housing. The lightning protection device is used to protect sensitive lines and protect the lightning and direct lightning or other instantaneous overvoltage.
The lightning arrester adopts the multi-stage protection circuit, selects the brand components and makes use of the advanced production technology. It has the characteristics of large flow capacity, low residual pressure level, sensitive reaction, stable performance, reliable work and so on.

Product specification

Product features

1. copper fittings have good electrical conductivity

2. leakage current is small, the response time is fast, and the residual pressure is low

3. safety insulation of fire retardant and high flame retardant material

Notice of product

1. when installing, pay attention to the cable entering and leaving the surge protector. The cables should be separated to avoid the two coupling of surge.

2. identify the input / output interface identifier of the lightning protector, input the external line and output the connection device.

3. connect the grounding wire of the lightning protector with the ground wire of the lightning protection system.

Working principle of product

The lightning arrester can effectively protect the power equipment. Once the abnormal voltage appears, the lightning arrester will play a protective role. When the protected device is running under normal working voltage, the arrester will not work, and it will be regarded as a circuit for the ground.
Once the high voltage is present and the insulation of the protected equipment is endangered, the lightning arrester acts immediately and leads the high voltage impact current to the earth, thus limiting the amplitude of the voltage and protecting the insulation of the electrical equipment. When the overvoltage is gone, the arrester is restored to its original state quickly, so that the system can supply electricity normally.
The main function of the lightning arrester is to reduce the voltage value of the protected equipment through the action of parallel discharge gap or nonlinear resistance, and to reduce the voltage value of the protected equipment, so as to protect the power equipment.

Product Installation

With 35mm standard DIN-rail mounting, connecting copper stranded conductor is 2.5~35mm²

At front of spd each pole must be setted protection---used fuse or miniature circuit breaker lightning current SPD protection,after SPD breakdown to short circuit protection.

SPD install on protected line(equipment) to the front and connected to the supply line. A class products install in the building home-entry line hold larger surge current total distribution box. B, C class products most install on the floor distribution box, D class products close to the front-end equipment that smaller surge current, smaller residual voltage place.

Company profile