Menswear mandarin collar metal zip through tan mock suede biker jacket TW69110

Description

Trims list

Styling Details

Front:

Collar:
3cm wide stand up mandarin collar with stud fastening as sample.
To have foot stitching at top edge and edge stitching at neck seam.
Body:
To have zip through center front with flat piping on either side covering zip tape, leaving zip teeth exposed.
To have edge stitching on side of piped edge as sample.
Side zip pockets to be slanted as per sample with flat piping covering zip tape, leaving zip teeth exposed.
Side pkts - # 3 zips as per sample in gunmetal finish.
Zip length to be 17.5cm as per sample with edge stitching around
All zips to have DH branded zip pullers.
CF zip #5 as per sample in gunmetal finish.
Shoulder and armhole seams to be footstitched.
Sleeve and side seams to have edge stitch on either side of seam.
Hem to be straight as sample with a wider hem allowance of 2.5cm.
Sleeves:
To have long sleeves with separate cuffs as sample.
Cuff width to be 5cm with edge stitch at top seam and foot stitch at hem

To have branded popper on the cuff opening.

Back:

To have a horizontal back yoke 14cm below collar seam., foot stitched.
To have a 3.2cm wide box pleat at center back seam, below yoke, foot stitched on either side as sample.
Sleeves to be two piece with seam at back aligned wth back yoke seam at armhole seam.
Sleeve to have an 8cm long gauntlet above cuff.
Cuff to have a DH branded stud fastening inplace of buttons.

Inside:

To be fully lined with navy poly twill lining.
Colour as per sample

To have a self fabric center back loop
To have a self fabric portrait patch 2.5cm below collar seam.
Please add the navy/ white /red ottoman tape above and below portrait patch as per image attached.
The tape extending out at the bottom must form a 1cm loop doubled back under portrait patch.
Please include Daniel Hechter branded navy piping between lining and facing

Mearsurement

Specification