Men's Grey Polyester Bomber hooded Jacket With black rib and mesh lining TW83339

SPECIFICATIONS :

MEASUREMENTS:

Styling - Front:

HOOD:
- 3 Panel hood as per original.
- Panel seams of hood to be finished with foot stitch.
- Hood opening to be finished with tunnel stitch
- At drawcord opening to have 2x black coated eyelets. 9mm diameter.
- Chunky round drawcord; 8mm diameter, black, slightly finer weave than drawcord on sample.
- To have toggle on drawcord between the two eyelets as per sample
- Drawcord ending to come out at bottom of tunnel as per sample
- Drawcord endings to be rubber sealed; colour of seal = black. Drawcords must be knotted before sealing
- Front neck to be raised as per original.
- Finish neck seam with 5mm edge stitch.

SHOULDER SEAM:
Finish with edge stitch

CF ZIP:
-Change to size 5 reversed coated nylon coil zip
-To have branded black metal puller with black plastic tip. Tip to have raised swish

CHEST ZIP:
At LHSW
-Size 5 reverse nylon coil zip
-To have branded black metal puller with black plastic tip. Tip to have raised swish
-Zip to be concealed with a welt, finish welt with an edge stitch
-Functional pocket with poly lining

BOTTOM ZIPS:
-Slanted reverse nylon coil size 5 zips with rubber coating
-To have branded black black metal puller with black plastic tip. Tip to have raised swish

-Zips to have self fabric welt above zip, 2cm length
-Finish around zips with edge stitch
-Functional pocket with poly lining

PRINT AT RHSW:
- Chest print on LHSW chest
- Print to be 25mm in height, width adjusted propotionately

SIDE SEAM:
Finish with twin needle as per sample

HEM:
Self fabric inset at CF, finish with foot stitch
To have 1x1rib hem with good recovery, 5.5cm wide

SLEEVE:
-Standard set in sleeve
- Finish at armhole with foot stitch
- Cuff to be finished as original, 1x1 rib with good recovery. Cuff width 5.5cm
-Finish above cuff with foot stitch

BADGE ON SLEEVE:
Rubber badge
Black base, white wording

Back:

HOOD:
- 3 Panel hood as per sample.
- Panel seams of hood to be finished with foot stitch.
- Hood opening to be finished with tunnel stitch
- Finish neck seam with 5mm edge stitch.

BODY:
Horizontal cutline across back as per sample

SLEEVES:
As per front

HEM:
As per front

Inside:

HOOD LINING:
Mesh as original, black

BODY LINING:
Mesh as original, black

SLEEVE LINING:
To be poly as original, black

LABEL AT CB:
Black flat label with white wording, design attached
To be laid onto self fabric patch creating a 1cm border around label

TAPE LOOP:

As original, colour to be black

STORM FLAP:
As original, 2cm wide

INTERNAL POCKET:
Vetical welt pocket with popper closure as per sample
Finish with edge stitch

Specification