Batch Production 20T Self Aligning Welding Rotator with Remote Control Box

Description of self aligning welding rotator

1. It will adjust the tank diameters automatically.

2. Wireless control is more convenient than remote control cable.

3. Working range can be designed according to your tank diameter.

4. Low noise transmission and stable turning roller during working.

Delivery Package Range

1. One set powered / One set idler / Electric control system

2. Voltage : 380V 50Hz 3P

3. Control Way : Remote Control Box / Foot Pedal

4. Package Way : Wooden Case

5. Working Manual

Technical Data

Applications

1. The machine consists of 1 set of driving roller, 1 set of idler roller and electric control system.
2. The drive roller and idle roll must be put the foundation in same horizon. Two sets roller must be parallel to put, the ground horizontal plane must even. If the long-term usage base needs to be fixed.
3. Ensure that there is ample space for movement of the equipment, work piece as well as the operator.
4. The worm wheel decelerator of the machine adopts lubricating oil, other gears and bearings adopt grease lubrication, periodic change. Note: the lubricating oil isn't oiled into the machine at shipping, the users must oil assigned lubricating oil, and then begin to use.
5. Connect the 3-phase power supply only after all the mechanical and electrical installations have completed. Ensure that the phases are correct, if not the unit will not power up.

Details Control system and Brand

1. Inverter is from Taida/Yaskawa Brand

2. Motor is from CE Invertek Brand

3. Reducer is from Cable. Made in China.

4. Electric system is from Schneider

FAQ

Q: Can your machine or other products be customized?

A: yes,we are an professional manufacturer who specializes in welding equipment about 15 years,

we have a strong design team ,so any conventional products can be customized.

Q: What about the transportion?

A: Usually we take seaway ,cause its more convenient and cheaper for big machine,of course ,

if it is allowed ,we also can take train ,its according to real condition.

Attention please

1. When finished installation, check whether tight firmware of each port loosens to move the phenomenon or not, if have, please tighten them immediately.
2. Before the usage check the machine and clear some bar the on board ,the rubber roller can not get in touch with oil, and keep off the heat possibly.These will prevent gum the gum roller to aging.

3. We will supply you all the detail work manul for your reference.

DO NOT HESITATE ! JUST SEND US YOUR INQUIRY NOW.