High Accuracy Ultrasonic Sensor Distance Measurement Range 400…10000mm With PBT OR FRP Housing
Highlights
TECH-IN
Temperature compensate
LED for status indication
Battery powered
Minmal dead bands
Applications
Liquid and Solid Level Measurement
Tanks,Totes,Processing
Bulk Material Management
Factory automation
Position Detection
Avoid collision
Ultrasonic sensor | | UM10000-SR80-AI | Technical data | | | General Specifications | | Sensing distance | 400…10000mm | Adjustment range | 400…10000mm | Unusable area | 0…400mm | Standard target plate | 100mm×100mm | Transducer frequency About | 40 kHz | Response delay About | 150ms | Indicators/Operating means | | LED yellow | solid: NO LED flash: | LED red | flashing: | Electrical specifications | | | Operating voltage UB | 10…30VDC ripple10%ss 13…30VDC(Analog output 0-10V) | No-load supply current | ≤30mA | Output | | Output type | 1 analogue output 4---20mA | Resolution | | Deviation of the characteristic curve | ±1% of full-scale value | Repeat accuracy | ±0.1% of full-scale value | Load impedance | >1k Ohm | Maximum switching current | 200 mA | Temperature influence | ±1.5% of full-scale value | Ambient conditions | | Ambient temperature | -25…70℃ | Storage temperature | -40…85℃ | Mechanical specifications | | | Protection grade | IP68 | Connection | PVC cable,4-cables | Material | | Housing | PBT OR FRP | Transducer | epoxy resin/hollow glass sphere mixture; Polyurethane foam | 1 BN=BROWN 2 GN=GREEN 3 BU=BLUE 4 BK=BLACK | Weight | 280g | Compliance with standards and Directives | Standard conformity | EN 60947-5-2:2007 | |
Adjusting the evaluation limits The ultrasonic sensor features an analogue output with two teachable evaluation limits. These are set by applying the supply voltage -UB or +UB to the TEACH-IN input. The supply voltage must be applied to the TEACH-IN input for at least 1 s. indicate whether the sensor has recognised the target during the TEACH-IN procedure. The lower evaluation limit A1 is taught with -UB, A2 with +UB. Two different output functions can be set: 1. Analogue value increases with rising distance to object (rising ramp) 2. Analogue value falls with rising distance to object (falling ramp) Evaluation limits may only be specified within the first 5 minutes after Power on. To modify the evaluation limits later, the user may specify the desired values only after a new Power On. TEACH-IN rising ramp (A2 > A1) - Position object at lower evaluation limit - TEACH-IN lower limit A1 with - UB - Position object at upper evaluation limit - TEACH-IN upper limit A2 with + UB TEACH-IN falling ramp (A1 > A2): - Position object at lower evaluation limit - TEACH-IN lower limit A2 with + UB - Position object at upper evaluation limit - TEACH-IN upper limit A1 with - UB
Default setting A1: unusable area A2: nominal sensing range Mode of operation: rising ramp LED Displays (SR80 series no led) Displays in dependence on operating mode | Red LED | Blue LED | TEACH-IN evaluation limit Object detected No object detected Object uncertain (TEACH-IN invalid) | off off flashes | On off off | Normal mode (evaluation range) | off | on | Fault | on | previous state |
|
|