More photo of granite wall cladding

Project of Red Crabapple granite wall cladding


Dry hanging process of granite wall cladding

1. Clean up the grass roots, no pollutants at the grass-roots level.

2. Line: from both ends of the wall surface, from top to bottom up vertical lines, points on the ground or fixed point, find the vertical, generally according to the gap with the base board back (i.e. overhead layer) is appropriate for the 50~70mm, according to a vertical line up, connecting two points as the starting layer hanging plate base according to the elevation, base plate size and the width of gap pop-up vertical horizontal grid line.

3. Plate drilling: according to the design requirements in two to end the drilling location, pre concentrated marking, drilling, hole aperture is 5mm, Shenyi 30mm, vertical hole and end face of the vertical line.

4. Pendant mounting: according to the design and release Moxian pendant pendant specifications and quantity requirements, at the same time to force plate detection expansion bolts and connecting nut screwing efforts, so as to meet the design requirements of the quality.
5.In the end plate connection: plate hole, filled with epoxy resin mixture amount and insert the anchor pin, with epoxy resin mixture to ensure proper solidification time than, should be as specific and appropriate, generally in 4~8 hours, to avoid premature solidification and embrittlement, slow solidification and loose.
6.Plate installation: usually start viewing main or main facade, from top to bottom in turn a direction in order to install, to avoid cross operation to reduce the deviation, and pay attention to the consistency of color plates, each layer should be installed, a shape error correction, and to force plate on hand close the bolt fastening force pendant for sampling reinspection.
7.Sealing: after every construction section is installed, it can be cleaned without any mistake. It can clean up the seams, fill in the rubber strips, and then use the glue machine to do the silica gel sealant. The general silica gel only seals the surface of the flat joints or slightly concave than the boards. It is not suitable to apply silica gel when wet or sheet is dampened.
8.Cleaning: the operation site should be cleaned at the end of each operation, and the installation is not allowed to leave the sundries, so as to prevent the hardship from falling to the broken panel.

G561 Crapabble granite quarry corner