Product Name |
Influenza type A and type B Antigen Rapid Test |
Formats | Strip(3mm)Device(4mm) |
Place of Origen | China |
Specimen | swab |
Read Time | 15 minutes |
Shelf life | 2 years |
Package | 25 device/box or 50 strip/Box |
Storage | 2℃-30℃ |
For professional in vitro diagnostic use only
【DIRECTIONS FOR USE】
Allow the test device, reagents, and/or controls to reach room temperature (15°-30°C) before testing.
1. Remove the test Device from the sealed foil pouch and use it as soon as possible. Bestresults will be obtained if the assay is performed immediately after opening the foil pouch.
2. Place the Extraction Tube in the workstation. Hold the extraction reagent bottle upside down vertically. Squeeze the bottle and let the solution drop into the extraction tube freely without touching the edge of the tube. Add 10 drops of solution (Approx. 0.5ml) to the Extraction Tube.
3. Place the swab specimen in the Extraction Tube. Rotate the swab for approximately 10 seconds while pressing the head against the inside of the tube to release the antigen in the swab.
4. Remove the swab while squeezing the swab head against the inside of the Extraction Tube as you remove it to expel as much liquid as possible from the swab. Discard the swab in accordance with your biohazard waste disposal protocol.
5. Fit the dropper tip on top of the extraction test tube. Place the test device on a clean and level surface. Add 3 full drops of solution to the specimen well (S) and then start the timer.
6. Leave the Device in the tube and read results at 10 minutes. Do not interpret the result after 20 minutes.
Note: Very low concentrations of Flu A and/or Flu B antigen might result in a weak line
appearing in the test line regions (A and B) after an extended period of time; therefore, do not read results after 20 minutes.
POSITIVE RESULT:
|
POSITIVE: Influenza B Positive: * A colored band appears in the control band region (C) and another colored band appears in the B band region.
Influenza A Positive: * A colored band appears in the control band region (C) and another colored band appears in the A line region.
Influenza A+B Positive: * A colored band appears in the control line region (C) and two other colored bands appear in A line region and B line region respectively. |
NEGATIVE RESULT:
|
NEGATIVE: One colored band appears in the control band region (C). No band appears in the test band region (A/B). |
INVALID RESULT:
|
Control band fails to appear. Results from any test which has not produced a control band at the specified reading time must be discarded. Please review the procedure and repeat with a new test. If the problem persists, discontinue using the kit immediately and contact your local distributor. |