Rendering Pre-Breaker Model Is JSPSA-101 Rendering Plant Crusher

Crusher is used for crushing the whole animal carcasses, and various internal organs and bones from slaughterhouses.

Generally use crusher to reduce the size of the material and then delivery by screw conveyor or vane pump before cooking.

The motor model and the speed of the crushing shaft can be adjusted according to the production demand, the operation cost is low.The design of quick repair and replacement parts makes the crusher more efficient.

Installation and maintenance

The maintenance of the machine is an extremely important and frequent work. It should be closely coordinated with the extreme operation and overhaul. Full-time personnel conduct on-duty inspections. Installation test

1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.

2. Pay attention to the verticality between the main body and the horizontal when installing.

3. After installation, check whether the bolts in each part are loose and whether the door of the main engine is tight. If so, please tighten it.

4. Configure the power cord and control switch according to the power of the equipment.

5. After the inspection is completed, a no-load test run is performed, and the test run is normal and production can be started.

Machine maintenance

1. The shaft bears the full load of the negative machine, so good lubrication has a great relationship with the life of the bearing, and it directly affects the operation of the machine. Service life and operating rate, therefore, the injected lubricating oil must be clean and the seal must be good. The main oil filling point (1) of this machine is turned Moving bearings (2) Roll bearings (3) All gears (4) Moving bearings, sliding planes.

2. The newly installed wheel tyres are prone to looseness and must be checked frequently.

3. Pay attention to whether all parts of the machine work normally.

4. Pay attention to check the degree of wear of easily worn parts, and pay attention to replacing worn parts at any time.

5. On the plane of the bottom frame of the movable device, dust should be removed to prevent the movable bearing from being placed on the bottom frame when the machine encounters unbreakable materials. Moved up, resulting in a serious accident.

6. If the bearing oil temperature rises, stop and check the cause immediately to eliminate it.

7. If there is an impact sound when the rotating gear is running, stop and check it immediately and eliminate it