model is SWGZ1850 Carbon Steel Dyring Material Disc Dryer

With the saturated steam, hot water or heat conducting oil as heating medium, the vacuum rake dryer is an energy-saving and indirectheating drying equipment, which can be intermittently operated to dry the materials in vacuum condition. It can be mainly used for thedrying of slurry, paste, granular, powder, fiber, easily oxidized, heat sensitive materials.

The dryer cylinder section for toroidal welding, longitudinal along the entire circumference of not more than two weld article number, and shell welds shall be full, the minimum is not lower than the parent metal surface, the top should not be higher than 3 mm, feed plate weld should be smooth.Weld edge bite depth should not be greater than 0.5 mm, continuous length should not be greater than 100 mm, should not exceed the total length of each weld bite edge which 10% of the weld length.

The disc dryer produced by Jiangsu Sunrise is a low-energy, high-efficiency drying equipment. The utility model has the advantages of compact design, small floor space, convenient installation and debugging, and can be adapted to the drying requirements of various materials. The dryer is mainly used for continuous cooking or drying of animal or poultry by-products with low fat content, fish and fermented feather powder.

The disc dryer is indirectly heated by steam, and the heating surface is very concentrated, enabling the maximum evaporation capacity of the compact design to ensure efficient and uniform drying. The steam circulates between the hollow central tube and the arms, and the drying area is maximized. The material to be dried is injected from the inlet of the dryer, and the water continuously evaporates during the flow to the discharge port to ensure that the material reaching the discharge port reaches a set dryness.

We offer dryers of different models and materials depending on customer conditions and capacity requirements.