Technical data of Cap ridge roll forming machine

Cap ridge forming machine to make ridge cap suitable for steel roofing sheet top.Your ridge can be designed here.

Here are some popular ridge machines for your reference, stop to cut machine, working speed about 2-4m/min.

standard ridge with flat leg, which need to cut the leg according to roofing trapezoidal sheets during installing/

special ridge cutted according to roofing trapezoidal sheets, which can easily attached on roofing without futher cut during installing, which improve work efficiency greatly, and make great match to roofing sheets to water proof.

Saibo ridge cap forming machines include 3 ton manual decoiler, forming machine with post cut, PLC controller , hydraulic station, run out table. Mitsubishi or siemens control system allow you user friendly, you only put in the length and pieces , roll forming machine will automatically work.

1. Profile for reference

2. Specification of the material

3. Machine Detailed Parameters

4.Photos for reference




5. Maintenance and safety

1. There should be an earth wire independently connected to the ground.

2. Keep cleans all the electric components. Clean them once a month.

3. Do not open the door of the electric box except for cleaning and adjustment.

4. While doing the monthly cleaning, check the insulation and connecting conditions of each electric component. Make sure there is no heat generation or oxidization.

5. The machine: 380V/50HZ, operating parts: AC24V, Please refer to electric principle drawing and table for maintenance.

6. Do not modify system parameter unless the operator is specialized in controlling system
.
7. Once the system does not work properly, please send for specialized technicians or electricians for maintenance.

6.Machine picture for your reference: