25V 330UF Aluminum Electrolytic Capacitor Small Size And Large Capacity​

Aluminum electrolytic capacitor is a kind of electrolytic capacitor. It has the characteristics of large capacity and low cost. It is a widely used electronic component. Instrument matching.

The basic functions of aluminum electrolytic capacitors in electronic circuits are generally summarized as: pass through AC, block DC, have the functions of filtering, bypassing, coupling and fast charging and discharging, and have the characteristics of small size, large storage power, and high cost performance. With the advancement of modern technology and the continuous improvement of capacitor performance, aluminum electrolytic capacitors have been widely used in consumer electronics, communication products, computers and peripheral products, new energy, automation control, automotive industry, optoelectronic products, high-speed railways, aviation and military equipment etc.

​

Performance:

Capacitance tolerance: ±20% (120Hz, 20°C)
Operating temperature range: -55-+105°C
Rated voltage: 16V DC
Surge voltage: 18.4V DC
Dissipation factor (tan δ): 0.12
Measurement frequency: 120Hz
Temperature: 20°C
Measurement Voltage (V): no more than 0.5Vrms + 2.1-2.5V DC
Rated voltage: 16V DC
ESR: 12mΩ
Measurement frequency: 100-3,00kHz ±10%
Measurement voltage: no more than 0.5Vrms + 2.1-2.5V DC
Temperature: 20 ±10°C
Leakage current: the rated voltage shall be applied between terminals of capacitor such that the terminal voltage will reach the rated voltage with in two minute and the leakage current shall be measured at following time after the voltage has reached the rated voltage across a 1,000 ±10Ω series protection resistor
Then the current value shall not be exceed value calculated from following formula
Rated: 16V/270uF LC (2 minutes) 864uA

Temperature characteristics:

Measurement Impedance at +20 ±2°C, 1,00kHz ±20%
Measurement Impedance at -25 ±2°C, 1,00kHz ±20%
Measurement Impedance at -55 ±2°C, 100kHz ±20%
Impedance ratio of the -25 and -55°C values to the +20°C value shall be not exceed the following values