Aotuo-XM Coal Unloader with capacity 400~1500T/H

Description

Screw ship unloader is stationary mechanical drive screw ship unloader with two or three linked sections, it is mainly composed of vertical and horizontal spiral conveying equipments. Vertical and horizontal spiral motion is drived by hydraulic cylinder. This ship unloader is suitable for the size of 800~50000 DWT ships and the production capacity is 400 T/H~1500T/H. This type of ship unloader is suitable for unloading powder and granular materials.

The advantages of this model are as follows:

1. Environmental protection: no dust escapes during the whole process of coal unloading; High efficiency-high yield, 400 ~ 1500 t/h;

2. Long service life: high wear-resistant materials are used for the feeder and spiral blade of the coal unloader and the conveying pipe.

3. Wide adaptability: it can be applied to 800～50000 DWT bulk coal carriers to unload lump coal with water content of 20% and particle size of 200mm;

4. Low energy consumption: the energy consumption per ton is about 1 degree, which has obvious advantages of energy saving and environmental protection compared with grab coal unloader.

This product is developed by AOTUO in response to the current mandatory requirements of energy conservation and environmental protection for coal unloading in ports. It is a special equipment for coal unloading with good development prospects.

Technical Parameters

Capacity: 400 ~ 1500t/h (calculated according to cement bulk density)

Applicable ship type: 800~50000 DWT

Horizontal swivel angle of horizontal arm: ±135°

Pitch angle of horizontal arm: 30° for lifting up and 30° for probing down

Swing angle of vertical arm: 30° for inner swing and 40° for outer swing

Energy consumption: ≤1kwh/t

Noise: ≤ 80dB

Dust emission concentration: ≤ 10 mg/m³