Subway Intelligent Mechanism Swing Barrier Turnstile 40 Person/Min

Customized bridge gate gate flap adopts advanced fully automatic intelligent mechanism

Product Introduction:

1. This series of revolving door adopts our company's unique technology, precision photoelectric limit and gear positioning close.Due to a specific motor, the revolving door unlocks and resets.Closing is very accurate and stable.This series of revolving door adopts standard power socket.It can read the boom code card, ID card, IC card, etc.

2. There is a series of revolving doors.You can select items and specifications.Applicable to school, subway, indoor and other places.This collection is very high-tech.In order to ensure its safe use, please read this manual carefully!

Technical Parameters :

Installation method:
1. Determine the plan of the wing gate. When communicating with customers, determine the plan, the width and length of the site, and determine how many machines can be installed, whether to choose a vertical wing gate or a bridge wing gate. The overall dimensions of the vertical wing gate: 420x330x980 (mm), bridge wing Gate dimensions: 1200x280x1000 (mm), the size of the wing gate rod to the chassis is 510mm, that is, the vertical wing gate area: 420x (330+510), the bridge type wing gate area is 1200x (280+510), in confirmation When selecting the model, fully consider the gap between the gate and the gate rod, the area of ​​each wing gate, the placement position, how to wire it (whether to use the open line or the dark line), the plan is set, the goal is set, and the wing gate is waiting on site.

2. Fixed location wiring. According to the previously determined plan, clarify the specific dimensions of the wing gate installation, make a pre-embedded pipe, leave a 50-100mm gap between the gate and the gate, and open the upper cover to prevent adjustment of the machine, maintenance, etc., do not fail Leave a gap. Two plastic tubes of 6-8 minutes are embedded between the turnstile and the turnstile. One hose is used for the power line (strong current) and the other is used for the signal line (weak current). Do not connect the power cord to the The signal line runs through a rubber tube at the same time, which will affect the effect of communication. The embedded tube should be exposed to the ground 30-40mm high. The vertical wing gate should be at the bottom of the machine, and the bridge wing gate should be on both sides. (Because the bottom of the bridge wing gate is closed).

3. Fixed adjustment. The fixed bottom is fixed with 4-M10x100 expansion screws. It cannot swing. The whole machine is level and the appearance is consistent. (It is better to draw a straight line with a thin line before fixing, and the vertical and horizontal directions are the same). The wing gate and the wing gate are connected in series, one by one Adjust, the straight line can be used normally.

Detail photo :

Related Products :

Our Case :

Our company: