Genitec We are PCB separator expert. We provide PCB depaneling total solution.

Genitec founded in Taiwan in 1993. We have two factories for over 20000 square meters.

We produce most kind of PCB separator. Including PCB router, laser PCB separator, V-cut,

PCB/FPC punching machine.

If you have any project about PCB depaneling, welcome your inquiry, we will provide you solution.

PCB Separator​ Features

1. Fully automatic PCB router machine (hereinafter referred to as the machine),

is the company's many years of research and development,

through the actual combat verification of the success of the even plate division automatic production equipment.

2. The whole series is equipped with CCD automatic optical counterpoint system,

which greatly improves cutting accuracy and operation efficiency.

3. Use a high-speed spindle to make the cutting board of PCB board.

It has small stress, high precision and suitable for PCB board of any shape.

4. Double mesa motion, which can simultaneously perform split board cutting

and PCB board placement to improve operation efficiency.

5. The design of dust collecting iron net barrier prevents the abnormal loss of PCB board.

6. Patent high-efficiency dust collecting device, low noise, high efficiency, easy maintenance and cleanliness.

7. Windows operation system is safe, stable, easy to learn and easy to use.

PCB Separator​ Specification

PCB Separator​ Attention

1. Technical personnel should be sure to close the power supply when they are repaired.

When the power supply is opened, a special person should be assigned to guard against unrelated injuries

caused by unrelated personnel touching the operation button or switch.

2. When the following situations occur, the power supply should be shut down immediately and

professional maintenance technicians should be informed of the situation so as to facilitate the maintenance work.

(1) The power line or joint is worn and worn.

(2) Any liquid inflows into or contact the electrical Zero component.

(3) Although the operation is carried out according to the instruction manual, the machine is still not functioning properly.

(4) The machine has shown obvious changes in performance.

3. Firmly install the machine while installing, and delineate the dangerous area to prevent the unrelated

personnel from getting in and out, so as to ensure the safety of the operation.

4. If it is found that the water around or around the machine is damp or more watertight, do not send electricity before removing moisture (gas).