Brocade Compatible SFP+ 10G Transceiver SMF 10km 1310nm LC Duplex

10G-LR SFP+ 1310nm 10km DOM LC SMF Brocade Compatible 10GBase Transceiver

Product Descriptions

The Olinkcom's OLSP311XL-CD10 modules give you a wide variety of Gigabit Ethernet connectivity options for data center, enterprise wiring closet, and service provider transport applications.

Absolute Maximum Ratings

Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the transceiver.

Electrical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)

Note:

1. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.

2. Into 100Ω differential termination.

3. 20 – 80%. Measured with Module Compliance Test Board and OMA test pattern. Use of four 1’s and four 0’s sequence in the PRBS 9 is an acceptable alternative.

4. LOS is an open collector output. Should be pulled up with 4.7kΩ – 10kΩ on the host board. Normal operation is logic 0; loss of signal is logic 1.

Product Features

● Supports 11.3Gb/s bit rates

● Duplex LC connector

● Hot pluggable SFP+ footprint

● Uncooled 1310nm DFB transmitter, PIN photo-detector

● Applicable for 10km SMF connection

● Low power consumption, < 1W

● Digital Diagnostic Monitor Interface

● Optical interface compliant to IEEE 802.3ae 10GBASE-LR

● Electrical interface compliant to SFF-8431

● Operating case temperature: Commerical:0 to 70 °C

Applications

● 10GBASE-LR/LW at 10.3125Gbps and 10G Fiber Channel

● CPRI and OBSAI

● Other optical links

Optical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)

Notes:

1. Average power figures are informative only, per IEEE 802.3ae.

2. Measured at the BER less than 1E-12, back to back. The measure pattern is PRBS 2^31-1 with worst ER=4.5@ 10.3125Gb/s.