100G CFP2 LR4 10km Optic Transceivers Modules Cisco Compatibility DOM Lc Connector

RoHS Compliant 100Gb/s CFP2 LR4 10km Optical Transceiver

Product Features

● Supports up to 112Gbps bit rates

● Duplex LC connector

● Hot pluggable

● Operating electrical serial data rate up to 27.952493Gbps

● 4 parallel electrical serial interface

● Applicable for 10km SMF connection

● Low power consumption, < 6W

● Digital Diagnostic Monitor Interfacel

● MDIO Communication Interface

● Compliant with 100GBASE-LR4 and OTU4

● Operating case temperature:

Commerical:0 to 70 °C

Applications

● Local Area Network(LAN)

● Wide Area Network(WAN)

● Switch to router interface

● ITU-T OTU4 OTL4.4

Standards

● Compliant with IEEE 802.3ba

● Compliant with CFP2 MSA hardware specifications

● Compliant with CFP2 MSA management specifications

● Compliant with ITU-T G709/Y.1331

● Compliant with RoHS

Functional Description

Olinkphotonics’ OLCFXXTXL-CD10, 100G CFP2 LR4 optical transceiver integrates the transmit and receive path onto one module. On the transmit side, four lanes of serial data streams are recovered, retimed,and passed on to four laser drivers, which control four electric-absorption modulated lasers (EMLs) with 1296, 1300, 1305, and 1309 nm center wavelengths. The optical signals are then multiplexed into a single-mode fiber through an industry-standard LC connector.On the receive side, 4 lanes of optical data streams are optically demultiplexed by an integrated optical demultiplexer. Each data steam is recovered by a PIN photodetector and transimpedance amplifier, retimed, and passed on to an output driver. This module features a hot-pluggable electrical interface, low power consumption, and MDIO management interface.

Optical Characteristics

(Tested under recommended operating conditions,unless otherwise noted)

Notes:

1. The supply current includes CFP2 module’s supply current and test board workingcurrent.

2. Average launch power, each lane (min) is informative for 100GBase-LR4, not the principal indicator of signal strength.

3. The receiver shall be able to tolerate , without damage, continuous exposure to an optical input signal having this average power level

4. Average receive power, each lane (min) is informative and not the principal indicator

of signal strength. A received power below this value cannot be compliant; however, a value above this does not ensure compliance

5. Receiver sensitivity (OMA), each lane (max) is informative

6. Measured with conformance test signal at TP3 for BER=10-12

7. conditions of stressed receiver sensitivity test: vertical eye closure penalty for each lane is 1.8dB;stressed eye J2 jitter for each lane is 0.3UI; stressed eye J9 jitter for each lane is 0.47UI.

More details of our products:

High Reliable Optical Components and Excellent Design

1. DLB laser and PIN photodiode

• Long transmission distance.
• High speed and performance

2. Thick Gold Finger

• Stable operation
• Repeated plug and unplug

3. Plating Hard Gold Shell

• Good heat dissipation
• Can't be deformed easily
• Anti-electromagnetic interference

Cost-effective and Reliable Transmission

• Low power consumption and low latency allow your network devices to work efficiently
• DOM function supports real-time monitoring for transceiver status.