Good Flowability Flame Resistance Two-Part 1 To 1 Mix Silicone Encapsulant For General Potting For Connectors Sensors

Product Description
Silicone Encapsulant 160 Silicone Elastomer is a two component, room temperature or heat curing encapsulant that is used for general potting applications of power supplies. It has good flowability, moderate thermal conductivity, and flame resistance.

Typical Use
General potting applications: power supplies, connectors, sensors, industrial controls, transformers, amplifiers, high voltage resistor packs, relays.

Features

Easy mix with 1:1 proportion

Low viscosity, good flow ability

Room temperature cure or heat up cure

Thermal conduction, flame resistance

BENEFITS
Rapid, versatile cure processing controlled by temperature
Can be considered for uses requiring added flame resistance

Technical datasheet of Electronic Potting Silicone Compound& Encapsulates

Note: Mechanical and electrical performance data tested at 25°C 7 days after curing, relative humidity of 55%; all the tested data is average value.

Using Instructions of Electronic Potting Silicone Compound& Encapsulates

1. Preparing: clean up the coating surface, remove the rust, dust, oil dirt.

2. Pouring: weigh the silicone and catalyst correctly, mix silicone part A and part B thoroughly, pour onto the electronic components/surface after vacuum degassing.

3. Curing: room temperature cure or heat-up cure is both workable.

It should be use up after open the package, the material must be kept in a cool place sealed well, and it should avoid from contactwithmoisture in the air.

MIXING AND DE-AIRING
These products are supplied in a 1 to 1 mix ratio, which is very robust in manufacturing environments and allows for some process and dispense equipment variation. In most cases de-airing is not required.

PREPARING SURFACES
In applications requiring adhesion, priming will be required for many of the silicone encapsulants. For best results, the primer should be applied in a very thin, uniform coating and then wiped off after application. After application, it should be thoroughly cured prior to application of the silicone encapsulant. . Additional instructions for primer usage can be found in the information sheets specific to the individual primers.

Packaging of Electronic Potting Silicone Encapsulates

Packs are available in 20kg and 200kg per drum.

Storage & Transportation of Electronic Potting Silicone Encapsulates

Keep it from strong sunshine, heat, and store in cool & dry place, well sealed. It has a shelf life of 12 months.

It can be stroked and transported as non-dangerous goods.