IEC1010-I CAT 100V OEM Portable Mini Voltage Tester From China
Description:
1.2.1 When using, you must use the correct function and range.
1.2.2 Do not exceed the protection range of each range to measure the value.
1.2.3 Do not touch the top of the test leads (metal parts) when the meter is connected to the measuring circuit.
1.2.4 In the measurement, if the measured voltage is higher than 60V DC or 30V AC (RMS), should pay attention to keep the fingers always in the table after the finger care device.
1.2.5 Do not measure the voltage when the voltage between the measuring end and the earth exceeds AC 600V.
1.2.6 Before turning the change switch to change the measuring function, remove the test leads from the circuit under test.
1.2.7 Do not live measurement resistance, capacitance, diode and test circuit off.
Specification:
Applied Standard | IEC1010-I CAT.100V | ||
Function | Range | Accuracy | |
DC Voltage | 600mV/6V/60V/600V/1000V | ±(0.5%+3) | |
AC Voltage | 600mV/6V/60V/600V/750V | ±(0.8%+3) | |
DC Current | 60uA/600uA/6000uA/60mA/600mA/20A | ±(0.8%+3) | |
AC Current | 60uA/600uA/6000uA/60mA/600mA/20A | ±(1.0%+5) | |
Resistance | 600Ω/6kΩ/60kΩ/600kΩ/6MΩ/60MΩ | ±(0.8%+3) | |
Frequency | 10MHz | ±(1.0%+3) | |
Capacitance | 100mF | ±(4%+3) | |
Temperature | -50℃-1000℃/-58℉-1832℉ | ±(1.0%+4) | |
Duty Ration | 0.1%--99.9% | ±3% | |
Special Reature | |||
NCV | ✓ | Overload Protection | ✓ |
True-RMS | ✓ | Auto Power Off | ✓ |
Diode Test | ✓ | Back Light | ✓ |
HEF/Transistor | ✓ | Backlight Function | ✓ |
LED Torch | ✓ | On-off Buzzer | ✓ |
Low Battery Display | ✓ | Data Hold | ✓ |
Display | 5999 | ||
Size: | 190×90×50mm | Packing Size | 215*160*60mm |
N.W. | about 380g | G.W. | About 0.75kg |