SMT PANASONIC CM402 CM602 NPM 24 32mm DEEP POCKET 26mm EMBOSS FEEDER N610133537AA

Description:

Surface mounting was originally called "planar mounting".

Surface-mount technology was developed in the 1960s and became widely used in the mid 1980s. By the late 1990s, the great majority of high-tech electronic printed circuit assemblies were dominated by surface mount devices. Much of the pioneering work in this technology was done by IBM. The design approach first demonstrated by IBM in 1960 in a small-scale computer was later applied in the launch Vehicle Digital Computer used in the Instrument Unit that guided all Saturn IB and Saturn V vehicles. Components were mechanically redesigned to have small metal tabs or end caps that could be directly soldered to the surface of the PCB. Components became much smaller and component placement on both sides of a board became far more common with surface mounting than through-hole mounting, allowing much higher circuit densities and smaller circuit boards and, in turn, machines or subassemblies containing the boards.

Product Specification:

Supply Ability:
Sell new and used PANASONIC CM402 CM602 NPM Feeder in good condition:

• N610117446AE 4mm with sensor
• N610136725AA 8mm 0201
• N610136726AA 8mm 0201
• N610031080AA 8mm 0201
• KXFW1KS5A00 8mm with sensor
• KXFW1KSBA00 8mm without sensor
• KXFW1KS6A00 12mm 16mm with sensor
• KXFW1KSCA00 12mm 16mm without sensor
• KXFW1KS7A00 24mm 32mm with sensor
• KXFW1KSDA00 24mm 32mm without sensor
• N610004577AA N610133537AA 24mm 32mm deep pocket
• KXFW1KS8A00 44mm 56mm with sensor
• KXFW1KSEA00 44mm 56mm without sensor
• KXFW1L0YA00 N610133539AA 44mm 56mm deep pocket
• KXFW1KS9A00 72mm with sensor
• KXFW1KSFA00 72mm without sensor
• KXFW1L0ZA00 72mm deep pocket
• KXFW1KS10A00 88mm with sensor
• KXFW1KSEA00 88mm without sensor
• KXFW1KSRA00 N610005073AA Vibration feeder

Product Advantages:
Surface mount technology, SMT and its associated surface mount devices, SMDs considerably speed up PCB assembly as the components simply mount on the board.
Look inside any piece of commercially made electronic equipment these days and it is filled with minute devices. Rather than using traditional components with wire leads like those that may be used for home construction and kits, these components are mounted onto the surface of the boards and many are minute in size.

1.Better mechanical performance under shock and vibration conditions (partly due to lower mass, and partly due to less cantilevering)
2.Lower resistance and inductance at the connection; consequently, fewer unwanted RF signal effects and better and more predictable high-frequency performance.

3.Better EMC performance (lower radiated emissions) due to the smaller radiation loop area (because of the smaller package) and the lesser lead inductance.

4.Fewer holes need to be drilled. (Drilling PCBs is time-consuming and expensive.)

5.Lower initial cost and time of setting up for mass production, using automated equipment.

Stock Adequate: