Flat snowmobile dolly go jacks wheel dollies set of 3

Description:

The snowmobile kit is a three-piece device that allows turning with minimal clearance to safely maneuver the snowmobile in your storage area. As a suit, the product has a large load, with a strong steel plate design and hard rubber casters. The two front trolleys have grooves for snowmobile skis, with safety belts to prevent slippage.

Box Included :
1. 2 pcs 8*10” H Grooved steel plates
2. 1 pc 8*8” flat steel plate
3. 12pcs 3” hard rubber casters+12 sets screw+ nuts
4. 2 pcs 2*26” nylon strap

Feature:
1. For use moving or storing a snowmobile, snowplow or other large item
2. Rubber pad delivers add protection and non-slip
3. easy to assembly to use ,safe and efficient
4. 1500 lbs load capacity ,make easy work of maximum load

QA:

How do you tie the belt?

Answer:Pass the non-loop end of the strap through a slot on the top edge of the cart. Then pass the non-loop end of the strap through the loop end and tighten it. Then connect one end of the strap to the cart. Put the snowmobile skis on the trolley. Put the strap on the ski and pass it through another slot on the top edge of the trolley. Pull tight and return to the top of the ski, then push the Velcro pieces together.
Whats the best way to get your sled on this?

Each front ski one at a time first. If you pull upward on front of ski you can slide them into place. Next place rear dooly next to track at spot you want track to set upon it. Lift back straight up high enough to clear rear dolly and move rear of sleds over dolly and lower into place. Fairly simple to do.

Service:

If you have any questions about the products you have purchased, you can consult our customer service. If you have any questions, you are welcome to contact us online, email, or phone!