Wireless Solar Motion Sensor Light With 65 Lumen For Outdoor Lighting

• RANGE OF APPLICATION

Although it was originally designed for portable toilet facilities, but also can be

used for a variety of applications.Such as canopies for bikies, sheds, plastic toilet,

garages, carports, roof, etc.

• WAY OF INSTALLATION

Let the light charging under sunlight for at least 8hrs before first time using, cut

a hole of 20.5 inch diameter(according to the tube diameter of lamp) in the

roofing and insert into the light tube through, screwing back the black holding plate

and clear lens on the light tube in piece. Then the light will turn on automatically

at night when movement detected.

• WORKING MODE

The light fixed with day/night sensor and also PIR motion sensor.It will be activated

when people present or move in the detecting zone. The light will last on as long

as movement being detected and it will turn off in 45 seconds after people leaving

detecting zone.

• PARTS

1--- 1 x LED lamp and integrated solar panel

2---1 x Operation Manual

• FEATURES

1. Solar panel: polycrystalline 4V, 260mA

2. Rechargeable battery: lifepo4 battery 3.2V, 1200mAh

3. LED: 10 pieces supper bright LEDs

4. Max.Output Lumen: 65 lumens

5. Operation mode: Light sensor and PIR motion sensor

6. Delay time:45 seconds

• BATTERY REPLACEMENT

The battery is 3.2V 1200mAh Li-ion rechargeable battery which is easily replaceable.

If the battery begins to illuminate dimly or for short durations of time and you

know that it has had sufficient sunlight on the panel, you should replace the battery

in following way:

1. Take off the lamp from the roofing.
2. Remove the 4 screws on the plate without damaging cables.
3. Disjoin the old battery and replace a new battery.

4. WARNING – Polarity is important. Wrong polarity is dangerous and will destroy the unit.

Notes

• It is suggested to add a round soft material between light and holding

plate or use glass cement to glue all round of the light.So that water will not leak

into the house and even vapor cannot goes into the lamps.

• The light is not suggest to install where have intense air flow or over

cold or over heat place,such as air-condition, as these will make the PIR sensor

wrong function.