10 SMD LED Solar Powered Led Security Motion Detector Outdoor Light

• WHAT IS THE APPLICATION

This solar motion security light was originally designed for portable toilet lighting,

but after improvement it can also be used for the lighting of canopies,such as bikies,

sheds, plastic toilet, garages, carports, roof, etc.

• HOW TO INSTALL THE LIGHT

Simply cut a hole of 20.5 inch diameter ( 19.7 inch is the light tube) in the roofing

and insert into the light tube through, screwing back the black holding plate and

clear lens on the light tube in piece. Then the light will operate automatically at

night when movement detected and last for 45 seconds.

• HOW TO OPERATE

Let the light charging under sunlight for at least 8hrs before first time using.

The light is fixed with light sensor and also PIR motion sensor.At darkness, the

light can be activated when people present or move in the detecting zone.

The light will last on as long as movement being detected and it will turn off in

45 seconds after the object leaving detecting zone.

• WHAT IS CONTAINED

1--- 1 x solar lamp with battery build in

2---1 x User Manual

• LAMP FEATURES

1. Solar panel: polycrystalline 4V, 260mA

2. Rechargeable battery: lifepo4 battery 3.2V, 1200mAh

3. LED: 10 pieces supper bright LEDs

4. Max.Output Lumen: 65 lumens

5. Operation mode: Light sensor and PIR motion sensor

6. Delay time:45 seconds

• HOW TO REPLACE THE BATTERY

The battery is 3.2V 1200mAh Lifepo4 rechargeable battery which is easily

replaceable.

If the battery begins to illuminate dimly or for short time and you know

that it has had sufficient sunlight on the panel,you should replace the battery in

following way:

1. Take off the lens and holding plate,the pull off the lamp from the roofing.
2. Remove the 4 screws on the plate without damaging cables.
3. Disjoin the old battery and replace with a new battery.
4. Remount the unit back in piece.

5. WARNING – Polarity is important. Wrong polarity is dangerous and will destroy the unit.

Notes

• It is suggested to add a round soft material between light and holding plate or

use glass cement to glue all round of the light. So that water will not leak into

the house and even vapor cannot goes into the lamp.

• The light is not suggest to install where have intense air flow or over cold or

over heat place,such as air-condition, as these will make the PIR sensor wrong

function.