Homeuse 60AH Off Grid Solar Power System For Hotel Appliances

1. product introduction

This kit can provide power to small/medium household or office appliances such as LED lighting, TV, radio, computer, printer or a fridge. This may vary significantly according to the location and season.

This Homeuse 60AH Off Grid Solar Power System For Hotel Appliances Photonic Universe 60AH 24V Complete Off-grid Solar Power System is the perfect ready-to-use kit for off-grid applications requiring a reliable and constant source of power for household appliances or industrial equipment in areas without access to or without stable mains electricity.

Homeuse 220V 1-10KW New Off Grid Solar Power System For Household Appliances

2. off Grid solar power system range of Application

Homeuse 220V 1-10KW New Off Grid Solar Power System For Household Appliances

3. Advantange of off gird solar system

Off-grid photovoltaic system is an independent solution because it can be installed in most places and is easy to maintain locally. They are a reliable, clean and low-cost effective solution that can replace diesel generators.

4. Factors affecting the output power of photovoltaic power station

There are many factors affecting the output power of a photovoltaic power station, including solar radiation, tilt Angle of the cell module, dust and shadow blocking, temperature characteristics of the module and so on.System power is small due to improper system configuration and installation.

The solution is as follows:

Before installation, check whether the power of each component is sufficient;Adjust the installation Angle and orientation of the components;Check components for shadows and dust;Check whether the voltage is within the voltage range after the components are in series. If the voltage is too low, the system efficiency will be reduced.Before installation of multi-channel group series, check the open-circuit voltage of each group series, the difference is not more than 5V. If the voltage is not correct, check the line and joint.During installation, it can be accessed in batches. When each group is connected, the power of each group shall be recorded, and the power difference between the groups shall not exceed 2%.

If these methods do not work, there may be:

The installation place is not ventilated, the inverter heat is not spread out in time, or directly exposed in the sun, causing the inverter temperature is too high;The cable joint contact is poor, the cable is too long, the wire diameter is too thin, there is voltage loss, and finally cause power loss;The capacity of grid-connected AC switch in photovoltaic power station is too small to meet the output requirements of inverter.